Jupio JBG-C002 Instructions

Part Names
○,
Protective cover
1
Jupio Battery Grip JBG-C002
○,
Electrical contacts
2
○, Camera battery compartment cover slot
3
○,
Vertical- grip operation switch
4
Instructions
○,
Vertical-grip AF start button
5
○,
Vertical-grip AE lock/FE lock/ lndex/ Reduce
6
button
Thank you for purchasing this Original Jupio product.
○,
Vertical-grip AF point selection/Magnify button
7
The BG-E6 is a battery grip that can hold two Battery Packs LP-E6 or six
○,
Battery release lever
8
size-AA/LR6 batteries. It is also equipped with a vertical-grip shutter button,
○,
Battery compartment
9
○,
Battery compartment cover Main Dial, etc. to enable shooting in the same way as a horizontal grip.
10
○,
DC coupler cord mount
■ Attaching to the Camera
11
○,
Attach/detach knob
12
1. Remove the battery from the camera (Fig. 1).
○,
Guide pin
13
○, 2. Detach the camera's battery compartment cover.
Attachment screw
14
○, Battery compartment release lever
3. Insert the detached cover into its storage slot to ensure that it will not be lost
15
○,
Vertical-grip shutter button
16
(Fig. 3).
○,
Vertical grip Main Dial
17
4. Remove the protective cover, and then insert the electrical contacts into the
○,
Hand strap mount
18
○,
Tripod socket battery compartment (Fig, 4-① ).
19
○,
Battery magazine BGM-E6
20
5. Align the attachment screw with the camera's tripod socket, and then turn
the attach/detach knob to tighten securely to the camera (Fig. 4-②)．
▲ Be sure to attach the battery grip to the camera before inserting the
batteries. The results of the battery check may not be displayed properly if you
attach the battery grip to the camera with the batteries already inside.
▲ Before removing the battery grip from the camera, be sure to turn the
camera's power switch to<OFF>, and take out the batteries. After removing the
batteries, attach the protective cover to the electrical contacts.
■ Inserting the Battery Packs
1. Slide the lever as shown by the arrow and open the cover (Fig.5).
2. Press both release levers outward in the battery compartment, and remove
the battery magazine (Fig.6).
3. Insert one or two Battery Packs LP-E6 in the orientation shown on the
battery compartment cover (Fig. 7).
4. Close the battery compartment cover until it clicks into place.
● If only one battery pack is used, it may be inserted in either
the right or left sides.
● If two battery packs are inserted, power is supplied
simultaneously by both battery packs, Two battery packs with
different charging levels can be inserted and used without any
problems.
● Remove the battery packs from the battery grip when the
camera will not be used for an extended period.
■ Inserting Size-AA/LR6 Batteries
1. Insert the batteries into the Battery Magazine (Fig. 8).
Make sure the + and - battery contacts are properly oriented as
shown in the illustration.
2. Turn over the battery magazine so that the inserted batteries
are facing downward, and then insert the battery magazine until
the release lever locks into place (Fig. 9).
3. Close the battery compartment cover until it clicks into place.
▲ Fewer images can be shot when using size-AA/LR6 batteries. Also, fewer
images can be shot depending on the battery brand and storage conditions,
and so usage of size-AA/LR6 batteries is recommended only for emergencies.
▲ With size-AA/LR6 batteries, use six new batteries of the same brand at
temperatures above 20℃/68℉. The camera may not function when used in
low temperatures or old and new batteries are used together.
Jupio Europe b.v.
Wasaweg 27
9723 JD Groningen
The Netherlands
www.jupio.com
■ Using a Household Power Outlet
To connect to a household power outlet, use the AC Adapter Kit
ACK-E6 (sold separately). (Refer to ACK-E6 Instructions.)
1. Connect the DC coupler plug to the AC adapter. Connect the power
cord to the AC adapter, and insert the prongs into a power outlet.
2. Load the DC coupler into the left side of the battery compartment
(Fig. 10-① ), and pass the cord through the cord mount (Fig. 10-② ).
▲ Do not connect or disconnect the power cord while the camera's
power switch is set to <ON>.
■ Using the Battery Grip
Turning the vertical-grip operation switch to <ON> (Fig. 11) makes
the battery grip buttons and dial function in the same way as those
on the camera.
When shooting in the horizontal-grip position, turn the vertical-grip
operation switch to <OFF> so that you do not accidentally use the
buttons or dial on the battery grip.
Hand Strap E-1 (sold separately) can be used for enabling a
more secure grip.
■ Battery Life
Temperature: +23℃/0℃ 73℉/32℉ [Number of shots . approx.]
Model Shooting method Power supply
LP-E6x2
Viewfinder shooting
EOS 5D
AA alkaline/LR6 batteries
Mark II
Live View shooting LP-E6x2
● Based on CIPA (Camera & Imaging Products Association) testing
standards.
● The number of images that can be shot is reduced by holding the
shutter button halfway down for an extended time, and using the AF
frequently without shooting.
● The number of images that can be shot is reduced by frequent usage
of the LCD monitor.
● The battery level can be checked on the LCD panel of the camera
and in the viewfinder.
■ Specifications
Type: Jupio Battery grip for the EOS 5D Mark II
Power sources:. (1) One or two Battery Packs LP-E6
(2) AA alkaline/LR6 batteries x 6
(3) AC Adapter Kit
Power switch: Camera's power switch
Working temperature range:
O℃ - +40℃ / 32℉ - 104℉
Working humidity: 85% or iess
Dimensions: 149.1 (W) x 114.3 (H) x 76.3 (D) mm/
5.9 .(W) x 4.5 (H) x 3.0 (D) in.
Weight: Approx. 315 g/11.1 oz. (not including the power
supply or battery magazine)
USA and Canada only:
The Lithium ion/polymer battery is recyclable.
Please call 1-800-8-BATTERY for information on
how to recycle this battery.
Le Canada et les Etats-Unis seulement :
La batterie aux ions de lithium est recyclable.Pour
obtenir des renseignements sur les façons de
recycler cette batterie, veuillez appeler au
1-800-8-BATTERY.
Para los EE.UU. y Canadá solamente:
La batería de ion de litio es reciclable. Llame por
favor 1-800-8-BATTERY para la información sobre
cómo reciclar esta batería.
Possible
shots
1700/1500
300/100
400/360