Jupio JBG-N005 Instructions Manual

Jupio Battery Grip JBG-N005 Instructions
To ensure proper operation, read this manual thoroughly before
using this product. After reading, be sure to keep it where it can
be seen by all those who use the product. The D5100 takes one
or two EN-EL14 batteries only, especially suitable for shooting in
a large quantity or low temperatures environment.
It is also
possible to operate the battery grip using 6 pcs of AA batteries in the AA
lt features a vertical-grip shutter –release button to
batteries holder.
enable shooting in the same fashion as a horizontal grip.
Attaching to the camera
1. Remove the battery from the camera.
2. Pull out the camera's battery compartment cover a slanted
angle to detach.(Fig.2) Perform the operation an a table so as
not to drop the camera.
3.Insert the detached cover into its storage slot the ensure that it
will not be lost. when taking out the cover, press lightly on the
cover hinge and pull it out upward at a slanted angel.
4. Remove the protective cover, and then insert the electrical
contacts into the camera battery compartment.(Fig.3)
5. Align the attachment screw with the camera's tripod socket.
and then turn the attach/detach knob to tighten securely, With
the correct way to use your camera shutter cable (Fig.4)
＊ Do not further push open the battery compartment cover
when it is already open, Doing so may damage its hinge.
＊ Be sure to attach the battery grip to the camera before
inserting the batteries. The results of the battery check
may not be displayed properly if you attach the battery grip
to the camera with the batteries already inside.
＊ Before removing the battery grip from the camera. Be sure
to turn the camera's power switch to <OFF>,and take out
the batteries. After removing the batteries, attach the
protective cover to the electrical contacts.
Use the EN-EL14 Battery Packs
1.Tweak battery chamber latch, open battery Chamber Cover.
(Fig.5)
2.Insert the battery grip electrical contacts to camera's battery
chamber and align the attachment.(Fig.6-①/Fig.6-②)
3. Screw with the camera's tripod socket, then turn the attach/
detach knob to tighten securely.
4.After the installation is completed ,turn on the camera, and
make sure that the camera's LCD displays the figures.
5.To dispatch the battery grip, reverse the above steps.(Fig.7)
Caution
※ The battery grip is not waterproof
※ Never attempt to disassemble or repair the product yourself.
The battery grip warranty does not cover any malfunction
resulted from such actions.
※ Make sure that the battery is turned OFF when attaching the
battery grip. Batteries must be inserted accordingly(refer to
the polarity guide[+][-] shown),but, Remove the battery, must
be. Closed Camera
※ Remove the batteries from the battery grip when the camera is
not to be used for an extended period.
※ Do not short-circuit the battery grip with batteries installed.
※ Do not carry or store the battery grip with batteries installed
together with metallic objects.
Battery Status
Check the batteries capacity provided on the camera's
LCD panel
Temperature Low Normal
temperature 0℃ temperature 20℃
Two EN-EL14 Appro.3500 Appro.2000
Shooting battery
condition NO flash use
Two EN-EL14 Appro.1800 Appro.1500
battery
50% flash use
Specification:100.5*127*80mm
Weight:146.8g
Note: When using AA batteries the number of photos which can be taken
are drastically reduced. It always better to using EN-EL14 batteries.
All data are based on manufacturer's standard test result. We
apologize for any mistakes or misprints in the manual, Design
and specifications are subject to change without notice.
Jupio Europe b.v.
Wasaweg 27
9723 JD Groningen
The Netherlands
www.jupio.com