Download Print this page

Jupio JBG-N008 Instructions Manual

Battery grip

Advertisement

Available languages

Available languages

Quick Links

Jupio Battery Grip
JBG-N008
Safety Precautions
To ensure proper operation, read this manual thoroughly before using this product.
After reading, be sure to keep it where it can be seen by all those who use the product.
Notice for Customers in Europe
This symbol indicates that this product is to be collected separately.
The following apply only to users in European countries;
● This product is designated for separate collection at an appropriate collection point. Do not dispose of as household waste.
● For more information, contact the retailer or the local authorities in charge of waste management.
Precautions for Use
● The JBG-N008 is for use with compatible devices only.
● Do not use with batteries and battery holders not recommended in this manual. The JBG-N008 cannot be used with rechargeable EN-EL3e/EN-EL3 Li-ion
batteries or the MS-D100 0r MS-D70 battery holders.
● To prevent electrical shorts caused by metal objects touching the power terminals, replace the contact cap when JBG-N008 is not in use.
● When the battery holder is removed from the JBG-N008 remove the batteries or place the holder in a container to prevent electrical shorts caused by
contact with other metal objects.
Should you notice smoke or an unusual smell or noise from the battery pack, discontinue use immediately. After removing the batteries, take the device to the
retailer or a Jupio authorized service representative for inspection.
● The JBG-N008 is not equipped with a power switch. Use the camera power switch to turn the power on or off.
EN-EL3e Batteries
The performance of EN-EL3e batteries drops at temperatures below about 10℃(50℉). Be sure the battery is fully charged and keep a warm spare battery on
hand ready to exchange as necessary. Cold batteries will recover some of their charge when warmed.
AA-Batteries
Due to their limited capacity, AA LR6 alkaline and ZR6 nickel-manganese batteries should be used only when no other alternative is available. Do not use at
low temperatures. In general, AA batteries have less capacity EN-EL3e batteries when used in the JBG-N008;EN-EL3e batteries are recommended for best
performance.
The capacity of AA batteries varies with make and storage conditions; in some cases, they may cease to function before their expiry date. Note that the
capacity of AA batteries drops sharply at temperatures below 20℃ (68℉)
Introduction
Thank you for your purchase of an JBG-N008 multi-power battery pack for use with Nikon D80/D90 single-lens reflex digital cameras. the JBG-N008 takes
one or two EN-EL3e rechargeable batteries s or six AA batteries (alkaline, Ni-MH, lithium, or nickel-manganese) and includes an alternate shutter-release
button, AE-L/AF-L button, and main and sub-command dials for taking pictures in "tall" (portrait) orientation.
Parts of the JBG-N008 (Figure A)
○,
Contact cap
1
○,
2
Signal contacts
○,
Power terminals
3
○,
Main command dial
4
○,
AE-LIAF-L button
5
○,
Battery-chamber cover
6
○,
7
Battery-chamber latch
○,
Attachment wheel
8
○,
Mounting screw
9
○,
10
Holder for battery-chamber cover
○,
Shutter -release button
11
○,
12
Control lock
○,
Sub-command dial
13
○,
14
Tripod socket
○,
15
Battery chamber
○,
Battery latches
16
○,
17
L slot
○,
R slot
18
○,
19
MS-D200 battery holder
○,
Battery holder power terminals
20
The MS-D200 battery holder is inserted in the JBG-N008 at shipment. See "Removing the Batteries " for information on removing the battery holder.
The Control Lock
The control lock (Figure A-○,
12
) locks the shutter-release button, AE-L/AF-L button, and main and sub-command dials on the JBG-N008 to prevent
unintended use. Before using these controls to take photographs in vertical (portrait) orientation, select ●to release the lock. The control lock is not a power
switch. Use the camera power switch to turn the camera on and off.
The Shutter-Release Button and Command Dials
The JBG-N008 is equipped with a shutter-release button (Figure A-○,
11
), main command dial (Figure A-○,
when taking photographs in vertical (portrait) orientation. These controls perform the same functions as the corresponding controls on the camera. See the
camera manual to Digital Photography for more information. Changes to Custom Setting 15 (Command dials) on the D80 or to Custom Setting f5( Customize
command dials) on the D90 also apply to the command dials on the JBG-N008.See the camera manual to Digital Photography for details.
The AE-L/AF-L Button
The JBG-N008 is equipped with an alternate AE-L/AF-L button for use when taking photo graphs in "tall" (portrait) orientation. This button performs the same
functions as the AE-L/AF-L button on the camera and is affected by changes to Custom Setting 18 (AE-L/AF-L). See the camera Guide Digital Photography
for details.
Using the Battery Pack
Attaching the Battery Pack
Before attaching the battery pack, be sure that the camera is off and that JBG-N008 control lock (Figure A-○,
1 Remove the contact cap (Figure A-○,
) from the battery pack. Be sure to replace the cap when the JBG-N008 is not in use, The cap can be threaded onto
1
the camera strap when removed from the battery pack.
2 Open the camera battery-chamber cover and remove it from the base of the camera battery-chamber as shown in Figure B. Remove the battery. if present,
and place the camera battery-chamber cover in the battery-chamber cover holder (Figure C). A PB-6D and PK-13 auto-extension ring are required when
using PB-6 bellows with the JBG-N008.
3 Insert the JBG-N008 as shown in Figure D.
4 Firmly tighten the attachment wheel by rotating it in the direction shown by the LOCK arrow (Figure E).
Removing the Battery Pack
To remove the JBG-N008, turn the camera off and set the control lock on the JBG-N008 to L and then follow the above steps in the reverse order.
Be sure to place the camera battery-chamber cover in the battery-chamber cover holder to prevent loss.
Jupio Europe b.v.
Wasaweg 27
9723 JD Groningen
The Netherlands
www.jupio.com
Inserting Batteries
The JBG-N008 can be used with one or two EN-EL3e rechargeable Li-ion batteries, or with six AA batteries inserted in the AA Battery magazine.
Before inserting batteries, be sure that the camera is off and that JBG-N008 control lock is in the L portion.
1 Turn the battery-chamber latch on the back of the JBG-N008 to
2 Insert the batteries.
EN-EL3e: Insert the batteries as shown on the inside of the battery chamber cover. The battery latch will slide aside during insertion and pop up to lock the
battery in place when fully inserted (Figure G). If only one battery is used, it may be inserted into either slot.
AA: Place six AA batteries in the AA Battery magazine as shown below and slide the holder into the battery chamber. The two battery latches (Figure H-○,
will slide aside during insertion (Figure H-○,
3 Close and latch the battery-chamber cover (Figure l). Make sure the cover fully closed before turning the latch.
4 Turn the camera on and check the battery level in the control panel or viewfinder. If EN-EL3e batteries are used, battery level can also be verified by mean
of the Battery info option in the camera setup menu.
Using an AC Adapter
If the JBG-N008is inserted in the camera, be sure to remove AA batteries before connecting an AC adapter, Failure to observe this
precaution may shorten the life of AA batteries.
Use EN-EL3e batteries if possible. AA batteries have less capacity and suffer a marked drop in performance at low temperatures.
When using AA batteries, note that all six batteries must be of the same type.
Note that the JBG-N008 can also be inserted in the camera after the battery or battery holder is inserted.
Battery Level
The camera displays battery level as follows:
EN-EL3e Batteries
Control panel
Viewfinder
-------
-------
(blinks)
(blinks)
AA Batteries
Control panel
Viewfinder
-------
(blinks)
(blinks)
Battery Info
The Battery info option in the camera setup menu displays information on EN-EL3e batteries. See the camera manual for details. Battery information is listed
separately for each slot. The Battery info option is not available with AA batteries.
Removing the Batteries
Being careful not to drop the battery or holder, remove them as shown below.
AA batteries can be removed from the AA battery pack using the holes in the back of the holder. Be careful not to drop the batteries when removing them from
the holder.
4
), and sub-command dial (Figure A-○,
13
) for use
) is in the L position.
12
Specifications
Power source
Battery life
Operating temperature
Dimensions
Weight
Measured at room temperature(20℃ /68℉) with a Zoom Nikkor AF-S DX 18-135 mm f/3.5-5.6G IF ED lens under the following standard Nikon
test conditions: continuous shooting mode; continuous-servo autofocus; image quality set to JPEG Basic; image size set to M(medium);
shutter-speed 1/250S; shutter-release button pressed halfway for three seconds and focus cycled from infinity to minimum range three times; after
six shots, monitor turned on for five seconds and then turned off; cycle repeated once exposure meters have turned off.
Specification and design are subject to change without notice.
and open the battery-chamber cover (Figure F).
2
)and pop up to lock the battery holder in place when fully inserted.
To ensure that the camera shows the correct battery level
when AA batteries are used, choose the appropriate option
for Custom Setting 32(JBG-N008 batteries)in the camera
Custom Settings menu. If the correct option is not selected,
Description
the camera may fail to function as expected.
Battery fully charged.
Battery partially
discharged.
Low battery. Ready spare
Battery type
batteries.
AA alkaline(LR6)
LR6(AA alkaline)
AA Ni-MH(HR6)
HR6(AA Ni-MH)
Battery exhausted.
AA Lithium(FR6)
FR6(AA Lithium)
Shutter release disabled.
AA nickel-manganese(ZR6)
AA nickel-manganese(ZR6)
Remove the batteries when JBG-N008 is not in use.
Description
Battery fully charged
Low battery. Ready spare
batteries.
Battery exhausted.
Shutter release disabled.
One or two EN-EL3e rechargeable Li-ion batteries; six LR6 alkaline, HR6 N1-MH,FR6 lithium, or ZR6
nickel-manganese AA batteries.
D80:Approximately 5000 shots (two EN-EL3e batteries),2500 shots(one EN-EL3e battery),or 480 shots
(alkaline batteries).
D90: Approximately 8400 shots (two EN-EL3e batteries),4200 shots(one EN-EL3e battery),or 1900 shots
(alkaline batteries)
0-+40℃ (+32-140℉)
Approximately138(W)x73.5(D)x110(H)mm/5.4x2.9x4.3in.
Approximately 230g(7.40z),excluding batteries
)
1
Option

Advertisement

loading
Need help?

Need help?

Do you have a question about the JBG-N008 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Jupio JBG-N008

  • Page 1 4 Firmly tighten the attachment wheel by rotating it in the direction shown by the LOCK arrow (Figure E). (alkaline batteries) Removing the Battery Pack To remove the JBG-N008, turn the camera off and set the control lock on the JBG-N008 to L and then follow the above steps in the reverse order. Operating temperature 0-+40℃ (+32-140℉) Be sure to place the camera battery-chamber cover in the battery-chamber cover holder to prevent loss.
  • Page 2 Batterijen plaatsen De JBG-N008 kan met een of twee EN-EL3e oplaadbare Li-ion batterijen gebruikt worden, of met zes AA batterijen geplaatst in de AA batterijcassette. BELANGRIJK: Gebruik EN-EL3e batterijen indien mogelijk. AA batterijen hebben minder capaciteit en werken minder goed bij lage temperaturen. Bij gebruik van AA batterijen, a.u.b. zes identieke batterijen gebruiken.
  • Page 3 9723 JD Groningen The Netherlands www.jupio.com AA batterijen kunnen uit de JBG-N008 verwijderd worden m.b.v. de gaten aan de achterkant van de houder. Let op dat de batterijen niet vallen bij het verwijderen Het controleslot Het controleslot (Figuur A-○, 12 ) sluit de sluiterknop, AE-L/AF-L knop en hoofd en sub-instelschijven op de JBG-N008 om onbedoeld gebruik te voorkomen.
  • Page 4 Umschreibung Gebrauch ist. Batterien komplett Batterien entfernen wenn JBG-N008 nicht in Gebrauch ● Wenn der Batteriehalter aus dem JBG-N008 entfernt wird, die Batterien entfernen oder Halter in Kasten stellen um Kurzschluss verursacht von Kontakt mit ------- aufgeladen ist. Low battery. Ersatzbatterie anderen Metallobjekten zu verhindern.
  • Page 5 Während Versand wird der JBG-N008 Batteriehalter in den JBG-N008 gesteckt. Sehen Sie “Batterien entfernen” für Info über Entfernung Batteriehalter. AA Batterien können aus dem JBG-N008 entfernt werden mithilfe der Löcher an der Rückseite des Halters. Achten Sie darauf, dass die Batterien nicht fallen. Das Kontrolle-Schloss Das Kontrolle-Schloss (Figur A-○, 12 ) schließt die Verschlusstaste, AF-ON Taste und Haupt- und Sub-Einstellräder um unbeabsichtigte Verwendung zu...
  • Page 6 ● Aby sa zabránilo skratu spôsobenému stykom kontaktov s kovovými predmetmi, po použití JBG-N008 nasaďte späť krytku elektrických kontaktov. ● Po tom, čo z JBG-N008 vyberiete držiak batérií, vyberte z držiaka batérie alebo držiak uložte do puzdra, aby sa zabránilo skratu kontaktov s kovovými Slabá...