Guldmann GH1 F Quick Manual

Quick Guide – GH1 F
• The ceiling hoist is switched on by pressing
one of the buttons on the hand control.
• If the hoist does not switch on, this may be be-
cause the emergency stop has been activated.
• Attach the travelling trolley anchor with cord to
the locking mechanism at the top of the hoist.
Press the button on the top of the hand
control. The button will illuminate when in instal-
lation mode. For activating the installation press
briefly on . Wait for a long continuous beep
confirming that installation is complete. When
GH1 F is locked in the travelling trolley press
again to stop installation mode. The hoist can
now be used for lifting using the
• For deinstallation of the hoist, choose the
and press briefly the
cord is fully extended before releasing the hoist
anchor. Press again to complete deinstalla-
tion mode.
• The hoist can be recharged by inserting the
hand control in the charging station placed on
and .
to activate. Wait until the
the transport trolley. The hand control should
always be inserted in the charging station when
not in use. The power supply must be connected
and switched on.
• The hoist's maximum lifting capacity will be
marked on the hoist, e.g., 255 kg. Note that the
rail system or the sling may have a lower lifting
capacity. The lowest lifting capacity may not be
exceeded.
• For further information see the GH1 F user
manual.