Back Panel; Initial Installation - Cisco WRV210 - Wireless-G VPN Router Administration Manual

Introduction

Initial Installation

Initial Installation
Cisco Small Business WRV210 Administration Guide

Back Panel

POWER—The Power port is where you connect the AC power cable.
RESET—The Reset button has two functions.
• If pressed for one second, the Reset button causes a warm reboot—the
Router restarts without losing any of the current configuration settings.
• If pressed for approximately 15 seconds, the Reset button resets the
Router's factory defaults.
You can also restore the factory defaults from the
screen of the Router's Configuration Utility.
INTERNET—The Internet port connects to your cable or DSL modem.
1-4 (ETHERNET)—The four Ethernet ports connect to your PCs and other network
devices.
Follow the instructions below to connect the equipment and configure the Internet
connection and wireless network.
• "Placement Options" on page 9
• Connecting the Equipment, page 9
• Verifying the Hardware Installation, page 11
• Configuring the Internet Connection, page 12
Administration > Factory Defaults
1
8