Adjusting The Time Settings - Cisco WRV210 - Wireless-G VPN Router Administration Manual

Setting Up the Network
Configuring the Basic Settings
STEP 3
STEP 1
STEP 2
Cisco Small Business WRV210 Administration Guide
• Number of Address: Enter the maximum number of PCs that you want the
DHCP server to assign IP addresses. This number cannot be greater than
253. The IP Address Range is determined by adding this number to the
Start IP Address.
• IP Address Range: The range of DHCP addresses that will be assigned,
based on your entries in the Start IP Address field and the Number of
Address field.
• Client Lease Time: Enter the number of seconds that a DHCP client can
keep an assigned IP address before it sends a renewal request to the DHCP
server. The default value is 86400 seconds, which is 24 hours.
• Assign Static IP: Click this button if you need to assign fixed IP addresses
to particular network devices. When the Static Table appears, enter the
Static IP Address and the MAC address of the device, then click Add. To
edit an entry, highlight the entry in the table, click Edit, make your changes in
the fields, then click Add. To remove an entry, highlight the entry, then click
Remove.
• User Defined DNS Servers: Check this box if you want to specify
particular DNS servers for your network. Then enter the DNS IP addresses
in the spaces provided.
Click Save to save your settings, or click Cancel to refresh the page with the
previously saved settings.
—OR— Complete other sections of the Basic Settings page before saving your
settings.

Adjusting the Time Settings

Click Setup > Basic Settings in the navigation tree.
In the Time Configuration section, enter the following information:
• Manually: Select the date from the Date drop-down menus. Then enter the
time in the Time fields.
• Automatically: Select your time zone from the Time Zone drop-down menu.
If you want to enable the Automatic Daylight Savings feature, click
Automatically adjust clock for daylight savings changes. If you want to use a
Network Time Protocol (NTP) server to set the time automatically, click User
Define NTP Server, then enter the IP address of the NTP server in the field.
2
24