Setting Up The Local Network - Cisco WRV210 - Wireless-G VPN Router Administration Manual

Setting Up the Network
Configuring the Basic Settings
STEP 4
STEP 1
STEP 2
Cisco Small Business WRV210 Administration Guide
• MTU: The MTU (Maximum Transmission Unit) setting specifies the largest
packet size permitted for network transmission. Select Enabled and enter
the value desired. It is recommended that you leave this value in the 1200 to
1500 range. For most DSL users, it is recommended to use the value 1492.
By default, MTU is set at 1500 when disabled.
• MTU Size: When Manual is selected in the MTU field, this option is enabled.
It is recommended that you set this value within the range of 1200 to 1500,
but the value can be defined between 128 and 1500.
Click Save to save your settings, or click Cancel to refresh the page with the
previously saved settings.
—OR— Complete other sections of the Basic Settings page before saving your
settings.

Setting Up the Local Network

Click Setup > Basic Settings in the navigation tree.
In the LAN Setup section, configure the Router's local network settings. In most
cases, you can keep the defaults.
• Local IP Address: Enter the IP address for the router on your network. The
default address is 192. 1 68. 1 . 1 .
• Subnet Mask: Enter the subnet mask for your network. The default value is
255.255.255.0.
• Local DHCP Server: The Router can be used as your network's DHCP
(Dynamic Host Configuration Protocol) server, which automatically assigns
an IP address to each connected device. Unless you already have a DHCP
server, it is highly recommended that you enable the DHCP server. This is
the default setting. If you already have a DHCP server on your network,
choose Disabled. If you disable DHCP, use the other router's configuration
utility to assign a static IP address to the WRV210.
• Start IP Address: Enter the first IP address in the range of addresses that
are assigned by the DHCP server. Assuming that you are using the default
router IP address of 192. 1 68. 1 . 1 , the Start IP address must be greater than
192. 1 68. 1 . 1 but smaller than 192. 1 68. 1 .255, which is reserved as the
broadcast IP address.
2
23