Ensure the grounding system is properly planted in the soil to reduce the chances of static discharge. Do not modify or alter the tool in any way. Only use Footage Tools replacement parts provided by the manufacturer or authorized distributor.
Page 3
C170 Hydraulic Steel Squeeze Off Tool for Steel Pipe DO NOT OPERATE THESE TOOLS UNLESS THESE INSTRUCTIONS HAVE BEEN CAREFULLY READ AND UNDERSTOOD SAFETY WARNING: WARNING: WHEN OPERATING THIS TOOL, SAFETY EQUIPMENT INCLUDING SAFETY GLASSES ARE REQUIRED BEFORE PERFORMING A SQUEEZE, CLEAN THE POCKETS ON UNDERSIDE OF LOWER BAR AND WHERE THE SIDE SHAFT WILL CONTACT THE LOWER BAR.
DO NOT OPERATE THESE TOOLS UNLESS THESE INSTRUCTIONS HAVE BEEN CAREFULLY READ AND UNDERSTOOD – PPE MUST ALSO BE WORN AT ALL TIMES This Footage Tools’ hydraulic steel squeeze off tool is designed to squeeze steel natural gas pipes from 1/2" to 2”...
Page 5
C170 Hydraulic Steel Squeeze Off Tool for Steel Pipe DO NOT OPERATE THESE TOOLS UNLESS THESE INSTRUCTIONS HAVE BEEN CAREFULLY READ AND UNDERSTOOD OPERATING INSTRUCTIONS: A. Installation of Pipe Inspect entire tool to ensure that it is clean and free from any dirt that may hinder proper operation before each use.
Page 6
C170 Hydraulic Steel Squeeze Off Tool for Steel Pipe DO NOT OPERATE THESE TOOLS UNLESS THESE INSTRUCTIONS HAVE BEEN CAREFULLY READ AND UNDERSTOOD OPERATING INSTRUCTIONS: B. Squeezing the Pipe Make sure the pipe is centrally located between the bars. Use the orange arrow on the upper bar to help Figure 5 center the pipe (Figure 5).
Page 7
C170 Hydraulic Steel Squeeze Off Tool for Steel Pipe DO NOT OPERATE THESE TOOLS UNLESS THESE INSTRUCTIONS HAVE BEEN CAREFULLY READ AND UNDERSTOOD OPERATING INSTRUCTIONS: C. Releasing the Pipe If the hydraulic pump has been disconnected, re- connect, as per procedure section A (step 2) on page # 2.
Page 8
C170 Hydraulic Steel Squeeze Off Tool for Steel Pipe DO NOT OPERATE THESE TOOLS UNLESS THESE INSTRUCTIONS HAVE BEEN CAREFULLY READ AND UNDERSTOOD OPERATING INSTRUCTIONS: D. Safety Precautions WARNING: When squeezing any sized steel pipe, DO NOT continue to squeeze after the bars have come in contact with the safety stops.
If you encounter a problem that you do not understand or cannot solve, contact your Footage Tools dealer. Ensure the tool is in good operating order by routinely checking the following:...
Page 11
FOOTAGE TOOLS INC within thirty days from the date of purchase. This warranty and any possible liability of FOOTAGE TOOLS INC hereunder is in lieu of all other warranties, expressed, implied, or statutory, including, but not limited to, any warranties of merchantability or fitness for a particular purpose.
Need help?
Do you have a question about the C170-A2 and is the answer not in the manual?
Questions and answers