Download
Share
Print this page
  1. Manuals
  2. Brands
  3. FOOTAGE Manuals
  4. Tools
  5. C170-A2
  6. Owner's manual

FOOTAGE C170-A2 Owner's Manual

1/2" - 2" hydraulic steel squeeze off tool
Hide thumbs Also See for C170-A2:

Advertisement

Quick Links

Download this manual
C 1 7 0 -A 2
1/2" - 2 " H y d r a u l i c S t e e l Squeeze Off Tool

Advertisement

loading
Need help?

Need help?

Do you have a question about the C170-A2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for FOOTAGE C170-A2

Summary of Contents for FOOTAGE C170-A2

  • Page 1 C 1 7 0 -A 2 1/2" - 2 " H y d r a u l i c S t e e l Squeeze Off Tool...
  • Page 3 - PPE MUST ALSO BE WORN AT ALL TIMES steel s designed to squeeze steel natural gas pipes from 1/2" to 2" knob pump (towards hose) pressurized/ start (close) knob (towards fill cap) 1) The hand pump is filled with ISO 32 weight hydraulic oil. TO CHECK OR REFILL, THE PUMP MUST BE CONNECTED TO TOOL AND TOOL MUST BE IN THE FULLY OPEN POSITION.
  • Page 4 With knob rotated backwards) the tool should be fully open. ring/pin (See picture 1) Place the pin /ring back in the locking position. orange and or pipe. (fully forward) to the pipe. whichever comes first and or pipe lifting up and NOTE: make note of the gauge pressure reading then rotate pump control knob backwards to release system pressure BEFORE disconnecting the fittings.
  • Page 5 A (step ) on page # 2 connected Note: slight (return to noted pressure) s fully lowered so that it is sitting (fully forward) (fully backwards) squeeze g/opening. (if open end of pipe is exposed) fully of tool on its own , the decrease of nitrogen pressure dirty cylinder rod guide slots See P reliminary A ssembl y (page # 1) or Maintenance...
  • Page 6 ny sized have come must be tees, joints, couplings, elbows, etc. any damaged or suspect parts or remove tool from service to prevent any injuries. ALWAYS WEAR YOUR PPE The C170 is designed to squeeze steel pipe - it is advised that users do in-house testingto determine what estimated hydraulic pump gauge pressure(s) might be required for the steel pipe within the utilities buried infrastructure network so that the potential for cutting the pipe is greatly reduced.
  • Page 7 distributor checking the following Top up as needed (tool must be connected to pump and too l must be in fully open position) a light no pipe in tool if required. Re-fill with a clean good quality ISO 32 oil and NOTE: pump must be connected to tool and tool must be fully open to determine correct oil level.

  • Page 10: Important Notice

    IMPORTANT NOTICE IMPORTANT NOTICE Warranty registration now available online. Please visit www.footagetools.com and click on ‘warranty registration’. 54 Audia Crt. Unit #1 Vaughan, Ontario Toll Free: 1-888-737-3668 www.footagetools.com Model: S/N: Tool Registration Card...