3Com TRANSCEND EM/NT 6.3 Installation Manual page 24

By default, all detected network protocols are selected.
4 If necessary, at the Select Network Protocols window, deselect a protocol
by clicking the box next to it to remove the check mark. Otherwise, click
Next to continue.
Setup next displays the Automatic Address Selection window.
Figure 10 Automatic Address Selection Window
The default is to prompt you to add addresses to the HP OpenView
polling list. You can also configure HP OpenView to select the first or last
address associated with a device in this window.
5 In the Automatic Address Selection window, click the appropriate radio
button to add addresses to the polling list, then click Next to continue.
This action displays the Select Program Folder window, where you select
the folder that contains the HP OpenView icons.
Installing HP OpenView 23