Workstation Requirements; Hardware Requirements - 3Com TRANSCEND EM/NT 6.3 Installation Manual

10 C 1: B
HAPTER EFORE
Check
Check
Workstation
Requirements
Hardware
Requirements
Y B
OU EGIN
Your system is now ready to install Transcend.
Table 5 Installation Checklist
Task
Run installation of Transcend WorkGroup Manager
6.2 for Windows.
Transcend has been installed and is ready to be prepared for operation.
Table 6 Post-installation Checklist
Task
Load the MIBs into OpenView if you didn't load
the MIBs during installation.
Determine whether any 3Com patches have been
released for Transcend WorkGroup Manager 6.2
for Windows NT.
Register Transcend.
Transcend has been installed and prepared for operation. To begin, see
Introducing Transcend Networking for details.
This section describes system requirements needed to run Transcend.
This section describes the workstation hardware requirements.
Intel (or 100% compatible) 200 MHz Pentium or faster microprocessor
I
64MB RAM minimum (128 MB recommended)
I
1 GB minimum hard disk space available on a single drive (drive does
I
not need to be the primary drive)
FAT16 or NTFS file system support
I
Paging file space should equal three times the RAM
I
To check paging file space, click Start, Settings, Control Panel,
Performance, Virtual Memory. Ensure that the Maximum Size of the
paging file is equal to three times the RAM.
For detailed information see
"Installing Transcend Applications"
on page 14.
For detailed information see
"Installing 3Com Enterprise MIBs"
on page 29.
"Additional Patches" on page 31.
"Product Registration" on
page 31.