H3C S9505 SRP Installation Manual page 98

Installation Manual
H3C S9500 Series Routing Switches
Note:
If the switch has two SRPUs, you also can copy the host and Boot ROM program files
to the standby SRPU.
2) Specify the next boot program. If the switch has two SRPUs, specify the load
programs respectively for the active and standby SRPUs. Suppose the current
standby SRPU is at slot 7.
Load Boot ROM program
<H3C> boot bootrom CF:/Switchbtm.btm slot 6
<H3C> boot bootrom CF:/Switchbtm.btm slot 7
Load host program
<H3C> boot boot-loader CF:/SWITCH002.app
<H3C>boot boot-loader CF:/SWITCH002.app
<H3C> display boot-loader
The app to boot of board 6 at the next time is: flash:/SWITCH002.app
The app to boot of board 6 at this time is: flash:/SWITCH001.app
The app to boot of board 7 at the next time is: flash:/SWITCH002.app
The app to boot of board 7 at this time is: flash:/SWITCH001.app
<H3C> reboot
Caution:
You must reboot the switch using the reboot command to validate the host
program.
Make sure that you have saved other configurations before reboot. Otherwise, they
might not survive a reboot.
Power-off is forbidden during loading process.
Boot ROM and host program loading is completed now.
II. Remote and local loading using TFTP
Using TFTP is similar to using FTP in remote and local loading via commands. The only
difference is that you use the tftp get command to download software to the switch. In
this case, the switch can only be used as a TFTP client to download the software to its
CF card from the TFTP server. The remaining steps after downloading are the same as
those of remote loading using FTP.
Chapter 5 Troubleshooting and Maintaining the Switch
5-24