Connecting The Aux Cable; Connecting Network Cables; Connecting Fiber - H3C S9505 SRP Installation Manual

Installation Manual
H3C S9500 Series Routing Switches

3.9.3 Connecting the AUX Cable

You need an AUX cable when configuring the S9500 series with the remote
modem dial-up approach.
I. Introduction
The AUX cable is an 8-core shielded cable. At one end of the cable is an
RS-232-compliant RJ-45 connector that can be plugged into the AUX port
of the switch. At the other end is DB-9 (male) connector. You can plug it
into the DB-9 (female) port of the modem. The AUX cable is the same as
the console cable. For details, refer to
II. Connecting AUX cable
1) Plug the RJ-45 connector of the AUX cable into the AUX port of the
switch.
2) Plug the DB-9 (male) connector at the other end into the serial port of
the modem.

3.9.4 Connecting Network Cables

I. Introduction to RJ-45 connector
The 10/100/1000Base-T ports of the S9500 series support MDI/MDI-X
auto-sensing. They are connected to category-5 shielded cables or above
that are equipped with RJ-45 connectors.
Figure 3-23 RJ-45 connector
II. Connection procedure
1) Plug one end of the network cable into the Ethernet RJ-45 port to be
connected on the switch.
2) Plug the other end of the cable into the RJ-45 port of the peer device.

3.9.5 Connecting Fiber

I. Installing fiber management tray (optional)
Figure 3-21
3-23
Chapter 3 Installing the Switch
and Table 3-3.