Chapter 5 System Commissioning; Configuration Environment Setup; Setting Up Networking Environment; Setting Terminal Parameters - H3C S7503 S7506 AND S7506R SWITCH Installation Manual

Installation Manual
H3C S7502 Ethernet Switch

Chapter 5 System Commissioning

5.1 Configuration Environment Setup

5.1.1 Setting up Networking Environment

A terminal (a PC in this example) is connected to the switch Console port through a
Console cable.
PC
Figure 5-1 Configuration environment
5.1.2 Connecting the Console Cable
Step 1: Plug the DB-9 female plug of the Console cable to the serial port of the PC or
the terminal where the switch is to be configured.
Step 2: Connect the RJ-45 connector of the Console cable to the Console port of the
switch.

5.1.3 Setting Terminal Parameters

Parameter requirements:
Bits per second: 9600
Data bits: 8
Parity: none
Stop bits: 1
Flow control: none
Emulation: VT100
Console port
Serial port
Console cable
5-1
Chapter 5 System Commissioning
Switch