Installation Manual
H3C S7502 Ethernet Switch
Chapter 7 Software Maintenance
You can use either the command lines or BOOT menu to load software onto the S7502.
7.1 Introduction to Loading Approaches
7.1.1 Loading Software Remotely and Locally through Command Lines
You can load the software:
By FTP
By TFTP
7.1.2 Loading Software Locally through Boot Menu
You can load the software:
From the console port using XModem
From an Ethernet port using TFTP
From an Ethernet port using FTP
Note:
Ensure that the Boot ROM version matches the host software version when you
load the Boot ROM and host software. You are recommended to load the Boot ROM
program only when the host software to be loaded does not match the existing Boot
ROM version. Frequent loading is discouraged.
The Boot Menu can only be used to load the Boot ROM program and host software
of SRPUs. To load the Boot ROM program of LPUs, use command lines.
7.2 Loading Software Locally through Boot Menu
If your terminal is directly connected to the switch, you can load Boot ROM and host
software locally.
Before loading the software, make sure that your terminal is correctly connected to the
switch.
Chapter 7 Software Maintenance
7-1