GRAUPNER Watercutter Operating Instructions Manual
GRAUPNER Watercutter Operating Instructions Manual

GRAUPNER Watercutter Operating Instructions Manual

Advertisement

Operating Instructions for the Model Watercutter
Order No. 2203
Description of the model
Almost-Ready-to-Run (ARTR) model
GRP hull and deck pre-bonded
Powerful brushless electric motor with hydro drive
Stainless steel drive and rudder shaft
Water-cooled moor, rudder linkages sealed with rubber accordion seals
Rudder servo and electronic speed controller pre-installed
Included in delivery: Hull pre-bonded with deck, cockpit canopy, motor, shaft with drive system
Ship stand, applied decal sheet, controller, and servo
Specification
Overall length about
Beam about
Total weight about
Manufacturer's declaration of the company Graupner GmbH & Co KG
Content of the manufacturer's declaration
If material defects or manufacturing faults should arise in a product distributed by us in the Federal Republic
of Germany and purchased by a consumer (§ 13 BGB), we, Graupner GmbH & Co. KG, Kirchheim/Teck,
Germany, acknowledge the obligation to correct those defects within the limitations described below.
The consumer is not entitled to make claims under this manufacturer's declaration if the failure in the usabil-
ity of the product is due to natural wear, use under competition conditions, incompetent or improper use (in-
cluding incorrect installation), or external influences.
This manufacturer's declaration does not affect the consumer's legal or contractual rights regarding defects
arising from the purchase contract between the consumer and the vendor (dealer).
Extent of the guarantee
If a claim is made under guarantee, we undertake at our discretion to repair or replace the defective goods.
We will not consider further claims, especially for reimbursement of costs relating to the defect (such as in-
stallation / removal costs) and compensation for consequent damages unless they are allowed by statute.
This does not affect claims based on legal regulations, especially according to product liability law.
Guarantee requirements
The purchaser is required to make the guarantee claim in writing and must enclose original proof of pur-
chase (such as invoice, receipt, delivery note) and this guarantee card. The defective goods must be sent to
us at the purchaser's own cost, using the address stated above.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Not liable for printing errors. We reserve the right to make technical modifications.
570 mm
275 mm
1.75 kg
Fa. Graupner GmbH & CO KG, Serviceabteilung,
Henriettenstr.94 -96, D 73230 Kirchheim/Teck
1
11/2011

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Watercutter and is the answer not in the manual?

Questions and answers

Summary of Contents for GRAUPNER Watercutter

  • Page 1 If material defects or manufacturing faults should arise in a product distributed by us in the Federal Republic of Germany and purchased by a consumer (§ 13 BGB), we, Graupner GmbH & Co. KG, Kirchheim/Teck, Germany, acknowledge the obligation to correct those defects within the limitations described below.
  • Page 2: Important Safety Notes

    For this reason GRAUPNER assumes no liability for losses, damage, or costs, which are incurred due to the incorrect use of our products or due to improper behaviour on the part of the user, or which are connected with such opera- tion in any way.
  • Page 3: Care And Maintenance

    All rechargeable and other batteries should also be removed from the model and transmitter and stored separately. GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY Not liable for printing errors. We reserve the right to make technical modifications.
  • Page 4 If water has penetrated the RC components, lay them out to dry and send them to the appropriate GRAUPNER service unit to be checked (see list of responsible service centres at the end of the instruc- tions). GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY Not liable for printing errors.
  • Page 5 (2) into the opening from above. When everything is fastened, tighten from the other side using the grub screw. GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY Not liable for printing errors. We reserve the right to make technical modifications.
  • Page 9: Trimming The Model

    If the model begins to "hop" when running fast, change the position of the drive mechanism until the model runs smoothly again, or move the batteries forward. Have fun running your model Watercutter GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY Not liable for printing errors. We reserve the right to make technical modifications. 11/2011...
  • Page 10: Spare Parts

    Electronic and electrical products may not be placed in the rubbish. Dispose of the product at the end of its useful life in accordance with applicable legal regulations. GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY Not liable for printing errors. We reserve the right to make technical modifications.
  • Page 11 (+44) 16 36 61 05 39 FAX (+46) 31 70 73 00 0 FAX (+44) 16 36 60 52 55 GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY Not liable for printing errors. We reserve the right to make technical modifications. 11/2011...

This manual is also suitable for:

2203

Table of Contents