1. Use as External USB HDD
1.1 Insert Hard Disk
Use 2.5" IDE Hard Disk for Laptop(or Notebook) PC.
Hard Disk should be "Master". However, if the Hard Disk supports "Single" mode, you need to try to set
"Single "mode.
① Grip the hasp and pull back
the front panel, and then open
the top cover.
④ Screw HDD on PCB by using
the supplied screws.
② Pull the PCB out.
⑤ Insert the PCB into the case,
and then close the top cover
and front panel.
6
③ Grip HDD and insert it into
the pins of PCB (be sure to
match the 44 pins)