Wacom DTF-720 Installation Manual And User's Manual page 22

Calibrating the DTF-720
You will need to calibrate the pen display tablet in order to align the screen cursor position with the
position of the pen on the display screen. This is required to adjust for parallax caused by the display
screen cover glass and coating. Set the DTF-720 in its working position, then follow the procedure
below.
Important: Make sure the LCD monitor is
properly adjusted before calibrating the tablet.
See Adjusting pitch and phase on page 27, and
Adjusting the LCD monitor beginning on
page 24.
• In the Tablet control panel, select the C
tab.
• If you are working with multiple monitors, select
the M corresponding to the DTF-720
ONITOR
display. (Only monitors that are set to one of the
resolutions supported by the DTF-720 will
appear in the list.)
• Click on the C
ALIBRATE
calibration screen.
• Holding the pen and positioning your head as
you normally do when working with the tablet,
use the pen tip to click on the center of the
cross-hairs in the upper-left corner.
• Then click on the center of the cross-hairs that
are displayed in the lower-right corner.
• Test the alignment by positioning the pen at a
few different points on the display. Click OK to
accept the calibration. Click T
recalibrate.
Be sure to read the directions in the calibration
screen for detailed instructions and additional
options. The calibration setting applies to all
applications.
Adjustment pattern for pitch and phase.
See Adjusting pitch and phase on
page 27 for details.
Note: If more than one pen display tablet is installed on your system, the control panel will change the settings
for the tablet that was last used before opening the control panel.
To calibrate two pen display tablets, first touch the pen to tablet #1 and open the control panel without touching
the pen to tablet #2. In the control panel, select the correct monitor and calibrate tablet #1. Close the control
panel, touch the pen to tablet #2, and again open the control panel without touching the pen to tablet #1.
Select the correct monitor and calibrate tablet #2.
Customizing
Page 20
ALIBRATE
button to activate the
A to
RY GAIN
Cross-hairs