Troubleshooting - D-Link DAP-3520 - AirPremier N Dual Band Exterior PoE Access Point User Manual

This chapter provides solutions to problems that can occur during the installation and operation of the DAP-3520 Wireless Access Point. We
will cover various aspects of the network setup, especially the network adapters. Please read the following if you are having any technical
difficulties.
Note: It is recommended that you use an Ethernet connection to configure the DAP-3520.
1..The.computer.used.to.configure.the.DAP-3520.cannot.access.the.Configuration.menu.
 Check if the LAN LED on the DAP-3520 is ON. If the.LED is not ON, check if the cable for the Ethernet connection is securely
inserted.
 Check if the Ethernet adapter is working properly. Please see item 3 of this Troubleshooting section to check that the drivers for the
network adapters are loaded properly.
 Check if the IP address is in the same range and subnet as the DAP-3520.
Note: The default IP address of the DAP-3520 is 192.168.0.50. All the computers on the network must have a unique IP address in the
same range, e.g. 192.168.0.x. Any computers that have identical IP addresses will not be visible on the network. They must all have the
same subnet mask, e.g. 255.255.255.0.
 Do a Ping test.to make sure that the DAP-3520 is responding. Go to.Start>Run>Type Command>Type ping.192.168.0.50..A
successful ping will show four replies.
Note: If you have changed the default IP address, make sure to ping the correct IP address assigned to the DAP-3520.
D-Lnk DAP-3520 User Manual

Troubleshooting