Table of Contents
Advertisement
2. Clip the two included ceiling brackets onto the
ceiling crossbar. Make sure both brackets are
positioned in line with each other.
Figure 10: Attaching the Ceiling Brackets
3. Using the included screws, secure the mounting
plate to the ceiling brackets.
Figure 11: Attaching Mounting Plate
4. Connect the Ethernet cable and power adapter
(optional) to the device.
5. Slide the DBA-1520P onto the mounting plate.
Figure 12: Securing the Access Point
Locking the DBA-1520P
If the lock plate was attached, insert a lock through
the device's lock slot to secure the DBA-1520P to the
mounting plate.
Ceiling crossbar
Ceiling bracket
Figure 13: Inserting a Physical Lock
Reboot/Reset the Access Point
If necessary, the DBA-1520P can be manually rebooted
or reset to factory default settings.
Rebooting the device
Press and hold down the reset button between
2 to 5 seconds and release to reboot the device.
Resetting the device
Press and hold down the reset button between
6 to 15 seconds and release to reset the device to its
factory default settings.
Press and hold down the reset button for
more than 15 seconds and release to reset the device
to its factory default settings and force the device to
load an alternate firmware.
Troubleshooting
The DBA-1520P receives its configuration settings and
is managed through the D-Link Nuclias cloud.
If you are experiencing problems connecting to the
D-Link Nuclias cloud, check your Internet connection.
If you still cannot connect to the service, additional
configuration on the device may be required. Refer to
the DBA-1520P User Nuclias Cloud Manual for detailed
information on how to manually configure the device.
Additional Information
For additional support, please refer to the user manual,
or visit your local D-Link support website.
Warning: The DBA-1520P is designed to receive PoE
power only from an 802.3at compliant source, or from a
D-Link-approved power adapter. Connecting an access
point to a Power over Ethernet (PoE) device that is not
approved by D-Link can damage the equipment.
Warning: This product is to be connected only to PoE
networks without routing to the outside plant. The
equipment power cord must be connected to a socket-
outlet earthling connection.
5
Advertisement
Table of Contents
