Configure Wep (Ap Mode) - D-Link AMPLIFI DAP-1525 User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based configuration by opening a web
browser and entering the IP address of the access point
(192.168.0.50). Click Setup and then Wireless Settings on
the left side.
2. Select Enable WEP Wireless Security (basic) in the Security
Mode drop-down menu in the Wireless Security Mode
section.
3. Next to WEP Encryption in the WEP section, select the
level of encryption (64-bit or 128-bit). Hex - (recommended)
Letters A-F and numbers 0-9 are valid.
4. Next to Default WEP Key and the first selection in the drop-
down menu, WEP Key 1. Enter a WEP key that you create in
the WEP Key value and Verify WEP Key value fields. Make
sure you enter this key exactly on all your wireless devices.
You may enter up to 4 different keys using the Default WEP
Key drop-down menu.
5. Select Open or Shared Key from the Authentication drop-
down menu.
6. Click Save Settings to save your settings. If you are
configuring the access point with a wireless adapter, you
will lose connectivity until you enable WEP on your adapter
and enter the same WEP key as you did on the access point.
D-Link DAP-1525 User Manual

Configure WEP (AP Mode)

65