Access Point Specifications - Cisco 1142 - Aironet Standalone AP Getting Started Manual

Add the option 43 line using the following syntax:
Step 4
option 43 hex <hex string>
The hex string is assembled by concatenating the TLV values shown below:
Type + Length + Value
Type is always f1(hex). Length is the number of controller management IP addresses times 4
in hex. Value is the IP address of the controller listed sequentially in hex.
For example, suppose that there are two controllers with management interface IP addresses,
10.126.126.2 and 10.127.127.2. The type is f1(hex). The length is 2 * 4 = 8 = 08 (hex). The IP
addresses translate to 0a7e7e02 and 0a7f7f02. Assembling the string then yields
f1080a7e7e020a7f7f02. The resulting Cisco IOS command added to the DHCP scope is option 43 hex
f1080a7e7e020a7f7f02.
11

Access Point Specifications

Table 2 lists the technical specifications for the 1140 series access point.
Table 2 Access Point Specifications
Category
Dimensions (LxWxD)
Weight
Operating temperature
Storage temperature
Humidity
Antenna
Compliance
32
Specification
8.68 x 8.68 x 1.84 in. (22.04 x 22.04 x 4.67 cm)
1.9 lbs (0.86 kg)
32 to 104 degrees F (0 to –40 degrees C)
–22 to 185 degrees F (–30 to 85 degrees C)
10% to 90% (noncondensing)
Integrated
The 1140 series access point complies with UL 2043 for products installed
in a building's environmental air handling spaces, such as above suspended
ceilings.