Table of Contents
Advertisement
(IK-DP30A dome base install)
(11) Attach the video cable (included with the dome
(12) Communication cables are directly inserted in
(13) Tighten the screw to secure the dome base to
(IK-DP30A dome drive install)
(14) After setting up DIP-SW in the top of the dome (See
(15) To lock the dome drive to the dome base, line up the
Ensure that the location of the notch (position of yellow paint) on the
dome base and the location of the installation label on the dome
drive are aligned.
(JK-H01A dome cover install)
(16) To lock the dome cover, insert the support wire and turn to the right with both hands.
(17) The installation is complete.
Downloaded from
www.Manualslib.com
accessories) to the video connector of a dome
base. [Note: Do not connect a thick coaxial cable
to a dome camera. There is a possibility of
damaging a connector. Be sure to use the cable
included in the dome accessories.]
the terminal of the dome base.
the housing. Fig-5 qwe
8.Switch setting), connect the support wire to the hook of
the dome base. Fig-6 q
notch with the label and turn to the right with both
hands. Fig-6 w
Fig-7, Fig-8
Fig-7
manuals search engine
w
q
Fig-8
- 36 -
e
FIg-5
q
w
Fig-6
Advertisement
Table of Contents
