Table of Contents
Advertisement
9. Installation
JK-H01A is a housing for ceiling mount of the Toshiba dome camera.
1. IK-DP30A Installation procedure
(1) Carefully inspect to insure all parts
(2) A template is included for ease in
(3) Remove the dome cover. To
(4) Loosen the lock screw according
(5) Install the camera mounting
Downloaded from
www.Manualslib.com
are present and remove all parts
from the box.
cutting the mounting hole. First,
locate a position in the ceiling for
a 9.020.08" (2292mm) hole to be
drilled. Trace around the template,
then cut a hole in the ceiling
following the trace lines. [Note: The
thickness of a ceiling to which this
housing can be attached is 0.08-
1.77" (2-45mm).]
separate the dome cover from the
housing, turn the cover to the left
with both hands. This dome cover
is connected to the top housing
with the wire. Fig-1
to ceiling board thickness for
attaching to the ceiling.
screws that came with the camera.
Do not fully tighten the screws.
manuals search engine
Lock
screw
- 34 -
Lock
screw
Fig-1
Advertisement
Table of Contents
