Page 2
Hewlett Packard Enterprise Company. To obtain such source code, please check if the code is available in the HPE Software Center at https://myenterpriselicense.hpe.com/cwp-ui/software...
Preface This document describes the hardware features of the HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway. It provides a detailed overview of the physical and performance characteristics of the Gateway and explains how to install the Gateway and its accessories.
Chapter 1 Gateway Components The HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway provides high-performance networking and SD-WAN in compact and cost-effective form factor, ideally suited for small branch and remote office environments. Table 2 describes the Gateway ports and their configuration.
Gateway. Front Panel Components Figure 1 shows the front panel of the EC-10150. Figure 1 Front Panel of the HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway Table 6 describes the front panel components. Table 6 Front Panel Components Item Number...
Rear Panel Components Figure 2 shows the back panel of the EC-10150. Figure 2 Back Panel of the HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway Table 7 describes the rear panel components:. Table 7 Rear Panel Components Item Component Name...
The UID button turns the UID LED Deactivated on/off. The UID LED locates and identifies a specific server that is deployed in a dense rack with other equipment. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Gateway Components |...
Page 9
One or more of the following conditions exists: Power is unavailable Power supply failure Power supply is in standby mode Power supply error Solid blue Activated Deactivated HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Gateway Components |...
Page 10
Port is transmitting or receiving data No link STATUS Port status Speed Green (Solid) Link at 1 Gbps Amber (Solid) Link at 1000 Mbps or 10 Mbps No link HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Gateway Components |...
Page 11
Gateway with USB-based Zero Touch Provisioning. More details are available at USB Based Zero Touch Provisioning | SD-WAN Orchestration Docs. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Gateway Components |...
can overheat the Gateway. Precautions Dangerous voltage above 240 V AC is always present while an HPE Aruba Networking gateway is plugged into an electrical outlet. Remove all rings, jewelry, and other potentially conductive material before working with this device.
2. Disconnect the power cord from the power supply. 3. Remove the power supply. Procedure – Replacing the Power Supply To replace the component, reverse the removal procedure. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Gateway warnings and cautions A fully populated gateway is heavy. HPE Aruba Networking recommends removing the external gateway components before removing the gateway from the rack. T-25 Torx screwdriver — This tool is required if the shipping screws located inside the chassis ears ...
Page 15
6. Slide the gateway completely out of the rack. 7. Place the gateway on a flat, level work surface. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
The Disk Management tab opens and displays all appliances with their disks (see figure below). c. Select the disk to be removed and click its Edit icon (shaped as a pencil). The Disk Management dialog box opens (see figure below). HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Page 17
Log into Appliance WebUI. b. Navigate to Configuration > Software & System Management > Disk Management. The Disk Management tab opens and displays all appliances with their disks (see figure below). HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Page 18
4. Bring the new drive online by returning to the Disk Management dialog box (Orchestrator) or Disk Management tab (WebUI). 5. Select the new drive and click Insert. This prompts the software to discover the disk and put the gateway online. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Page 19
Drive is online and has no activity Flashing green Drive is rebuilding One flash per second Flashing green Drive is online and has activity Four flashes per second Drive is not configured HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Select the disk to be removed and click its Edit icon (shaped as a pencil). The Disk Management dialog box opens (see the following figure). d. Select the disk to be removed and click the Remove button. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Page 21
Select the disk to be removed and click the Remove button. d. Confirm the removal action by clicking the Remove button on the Confirm dialog box. e. Proceed to step 2 on page HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Page 22
The device cage, which is not removable, is shown below to display carrier removal steps. Procedure – Replacing a System Drive To replace the system drive, reverse the removal procedure. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Page 23
Drive is online and has no activity Flashing green Drive is rebuilding One flash per second Flashing green Drive is online and has activity Four flashes per second Drive is not configured HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Pull and hold the release latch. b. Slide the rail towards the front panel and pull it from the gateway. c. Repeat steps a and b to remove the other sliding rail. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Page 25
Disengage the rail pins from the rack columns. c. Repeat steps a and b to remove the other rack rail. Procedure – Replacing the Rack Rails To replace the rack rails, reverse the removal procedure. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Installation |...
Chapter 3 Configuring the Gateway IMPORTANT - READ THIS FIRST: You must install and register your Orchestrator with the HPE Aruba Networking Cloud Portal BEFORE setting up an EdgeConnect gateway. After Orchestrator is registered with your account name and key, you can proceed with EdgeConnect installation. If you don’t know or are unsure about Orchestrator’s role, contact your network architect or deployment lead.
Turn the Power On The Gateway powers up as soon as it is plugged into the local power source. On the front panel, verify the Power LED illuminates green. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Configuring the Gateway |...
3. Complete the remaining wizard screens. On the Deployment page’s default configuration, the WAN–side interfaces use DHCP IP addresses, unless you manually enter static IP addresses. HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Configuring the Gateway |...
Safety and Compliance Information for Server, Storage, Power, Networking, and Rack Products HPE Aruba Networking gateways must be installed by a professional installer. The professional installer is responsible for ensuring that grounding is available and meets applicable local and national electrical codes.
Page 30
2. This device must accept any interference received, including interference that may cause unde- sired operation. Changes or modifications to this unit not expressly approved by HPE Aruba Networking could void the user’s authority to operate this equipment. Industry Canada Cet appareil numérique de la classe A est conforme à...
Page 31
China RoHS material content declaration HPE Aruba Networking EdgeConnect 10150 SD-WAN Gateway | Installation Guide Specifications, Safety, and Compliance |...
EU Regulatory Conformance The Declaration of Conformity made under EMC Directive 2014/30/EU is available for viewing at http://www.hpe.com/eu/certificates. Select the document that corresponds to your device’s model number as it is indicated on the product label. Use of controls or adjustments of performance or procedures other than those specified in this manual may result in hazardous radiation exposure.
Proper Disposal of HPE Aruba Networking Equipment Waste of Electrical and Electronic Equipment HPE Aruba Networking products at end of life are subject to separate collection and treatment in the EU Member States, Norway, and Switzerland and therefore are marked with the symbol shown at the left (crossed-out wheelie bin). The treatment...
Need help?
Do you have a question about the Aruba Networking EdgeConnect 10150 SD-WAN and is the answer not in the manual?
Questions and answers