Yamaha CRW2100S - CRW - CD-RW Drive Owner's Manual page 43

Are the pins and holes on the SCSI connectors straight and not deformed?
Check the connectors.
Is the terminator on the CRW2100S drive set correctly?
It should be set to ON only if it is the last device on the SCSI chain.
Otherwise, it should be set to OFF. ( P . 12)
Is the termination on the SCSI card set such that internal SCSI devices can be
connected?
Please read the instructions that came with your SCSI card for details.
To write to CD-R/RW discs, your CD writing software must support the
CRW2100S drive.
To find out if it does, contact the manufacturer of your CD writing software.
The disc tray does not come out.
Is the CRW2100S drive powered up?
Some CD writing software will lock the disc tray once loaded.
In which case, use the eject command from within the software. Alternatively,
read the manual that came with the software.
The disc keeps being ejected.
Has the disc been placed on the disc tray correctly?
The drive does not operate correctly.
Is the disc compatible with the CRW2100S drive?
n Even if the disc is of a type compatible with the CRW2100S drive, some varieties of
discs can still be unreadable on it.
Is there dust on the disc tray or on the disc itself?
Is the terminator of the last device on the SCSI chain set to "ON?" Or if it has
no built-in termination, has a terminator been attached?
Does the computer have a sufficient power supply?
The CRW2100S has a power consumption of 11W (when reading and
writing).
Does your computer have several different CD writing software installed?
If you use more than one CD writing software simultaneously, the behavior of
the drive can become unpredictable.
Troubleshooting
34