Rear Panel - Yamaha CRW2100S - CRW - CD-RW Drive Owner's Manual

Front and Rear of Unit

Rear Panel

The CRW2100S drive' s rear panel features the following:
AUDIO OUT connector
Connect one end of the 4-pin
audio cable to this and the
other end to your computer's
sound card or built-in audio.
(P. 19, 27)
AUDIO OUT
R G L 1 2 4
ID SELECT.......
PARITY..............
TERMINATOR..
BLOCK SIZE....
1 2 4
7
SCSI INTERFACE connector
Insert the connector of the SCSI ribbon cable here.
Make sure you align the red line of the ribbon cable with
pin 1 of the drive's connector, marked "SCSI
INTERFACE CONNECTOR 1." (P. 18, 26)
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1
2
3
4
1
ID SELECT jumper switches
Set these switches using black plastic
shunts in order to manually assign a SCSI ID
number for the drive.
2
PARITY jumper switch
Set this switch using a black plastic shunt in
order to enable parity checking.
3
TERMINATOR jumper switch
Set this switch using a black plastic shunt in
order to enable the drive's built-in SCSI
termination.
4
BLOCK SIZE jumper switch
Set this switch using a black plastic shunt in
order to set the block size to 512 bytes per
sector.
SCSI
INTERFACE
CONNECTOR
DC INPUT
+ 5V + 12V
1 G
DC INPUT connector
Insert the power connector
from your computer's
power supply in this socket
to feed power to the drive.
(P. 20, 28)