Yamaha CRW2100S - CRW - CD-RW Drive Owner's Manual page 28

Setup Procedures
7 Connect the audio cable between the CRW2100S drive and the
computer's sound card, or the motherboard's audio connector if it
has built-in audio. One end of the audio cable has two connectors: a
vertically-mounted type (PH) and a horizontally-mounted type
(MPC). Choose one that matches your sound card's connector. The
connector at other end of the cable is connected to "AUDIO OUT" of
the CRW2100S drive. Make sure connector's lug is at the top.
Audio cable
Horizontally-mounted
type (MPC)
Vertically-mounted
n You do not need to connect the audio cable to write audio CDs since the audio is
passed over the SCSI bus. It is required to play back audio CDs on the CRW2100S
drive via the computer' s sound card. However, if a CD-ROM drive is already
connected to the sound card, you should use this drive to play back your audio
CDs. To listen to audio CDs without a computer sound card, connect headphones
or speakers to the headphone jack on the CRW2100S drive' s front panel.
19
Lug
Sound card
type (PH)
S C S
I
IN T E
R F A
C O N C E
N E C
T O R