Table of Contents
Advertisement
7 Connect one end of the 50-pin SCSI flat cable to the computer's
SCSI card. Align the red line of the cable with Pin 1 of the card's
SCSI connector. Next, connect a free 50-pin connector on the SCSI
flat cable to the back of the CRW2100S drive such that the red line
on the cable is aligned with pin 1, marked "SCSI INTERFACE
CONNECTOR 1."
To Pin 1
About SCSI card termination
To connect internally-mounted SCSI devices, the SCSI card' s on-board
internal SCSI termination must be switched ON. With most cards, this is
done automatically. If your SCSI card requires that you manually disable
internal termination, refer to the documentation that came with it.
SCSI card
50-pin SCSI flat cable
S C S
I
IN T E
R F A
C O N
C E
N E C
T O R
SCSI
INTERFACE
CONNECTOR
1
Setup Procedures
Mark
Align red line
with Pin 1 of
SCSI INTERFACE
CONNECTOR 1
Pin 1
Align red line
with Pin 1 of
SCSI INTERFACE
CONNECTOR 1
Pin 1
26
Advertisement
Table of Contents
