Uniden UM380BK Owner's Manual page 14

You cannot transmit while in scan mode.
Using the radio in scan mode
You must have two or more channels in memory to start a scan.
x
To save a channel into memory, select the channel, then press and hold
x
seconds. Memory will show on the display.
x
To remove a channel from memory, set the radio to that channel, then press and hold
for two seconds. Memory will no longer show on the display.
x
To activate scan mode, press and hold
MEM
to the previous mode.
x
When the radio automatically stops on a channel, press
and resume scanning.
x
To end the scan, press the microphone's
radio remains on the last scanned channel.
x
If you activate Weather Alert Watch while operating in scan mode, the radio checks the most
Scan mode with Weather Alert Watch
recently-used weather channel
every seven seconds, then
continues scanning the next
channel in memory.
To turn Weather Alert Watch on
or off, press and hold
while the radio is idle. Select
Setup and then WX Alert Mode.
Use and
to choose WX Alert Mode
CHANNEL UP
setting ON or Off.
DOWN
If you activate Triple Watch while operating in scan mode, the radio checks channels 16 and
Scan mode with Triple and Dual Watch
9 every two seconds, then goes on
to scan the next channel; with
Dual Watch turned on, the radio
only checks channel 16.
Press and hold
radio for two seconds to turn
16/9-TRI
Triple/Dual Watch on or off. (To
change between Triple or Dual
Watch, see page 14.)
Press and hold the
mode.
CLR-SCAN
10 English
UM380_20101221.indd 10
CALL-MENU
CHANNEL
08 10
on the
key to turn off Scan mode and set the radio to Triple/Dual Watch
. Press and hold
CLR-SCAN
CHANNEL UP
PUSH TO TALK, CALL-MEM,
Memory Channel Scan
11 12 13 14
channels 9 & 16 then goes on
09 16
for two
WX-MEM
again to return
CLR-SCAN
to leave that channel
or buttons. The
WX-MEM
15 17 20 24 25
Triple Watch :
Every 2
seconds, the radio checks
to the next channel.
4/13/2011 11:25:09 AM
WX-