Storing Scanned Channels; Monitor; Drop-Out Delay; Battery Save - Uniden MHS050-2 Owner's Manual

Floating vhf marine radio

Hide thumbs Also See for MHS050-2:

Table of Contents

Storing Scanned Channels

1. Select the channel you want to store by pressing CH

2. Press and hold MEM. MEM displays and

you hear a double beep.

3. To remove channels from Memory, press

and hold MEM once more. A double beep

sounds and MEM disappears.

1. Press MON to start monitoring one channel with fixed (open)

squelch.

2. Press and hold MON for 2 seconds to hold

the monitor status on. All channel indicators

will start to flash.

3. Press MON again to release the monitoring

status.

Monitor is not available in Scan or Triple Watch modes

NOTE

While scanning, the radio stops on channels when it receives

a signal. When the received signal is over, the unit provides a

drop-out delay of 2 seconds for the return of the signal. After

2 seconds, if the signal does not return, the radio resumes

scanning.

This feature extends the battery life by switching the receiver

circuit power on and off. Battery Save automatically activates

during standby mode (RX mode without signal).

The Liquid Crystal Display (LCD) is backlit for easy viewing

at night or in low light situations. Backlighting automatically

E-16

Uniden MHS050-2 Owner's Manual

MEM

Table of Contents