Single alternate flow decentralized (single point) residential heat recovery unit, also called push&pull unit, designed to ensure adequate ventilation in enclosed environments without energy losses. (21 pages)
A single alternate flow decentralized (single point) residential heat recovery unit, also called push&pull unit, designed to ensure adequate ventilation in enclosed environments without energy losses (22 pages)
AMCA 230-15 AMCA 230-99 r/min W/(m W/(m 1170 1,40 20551 34917 144,3 29064 49380 102,1 AD1400B (1) Potenza max assorbita / portata max 6. DIMENSIONI E DISTANZE 1382 1273 1190 Ø10 1382 Punti di 1273 1190 sospensione o fissaggio a e r a...
7. COMPONENTI Pos. Descrizione Q.tà Girante Carcassa Motore 8. INSTALLAZIONE ATTENZIONE: Assicurarsi che l’interruttore generale dell’impianto sia spento prima di qualsiasi operazione di installazione, manutenzione o collegamento elettrico! Il ventilatore deve essere installato ad un’altezza non inferiore a 2,7m dal pavimento sottostante. Il ventilatore dovrà...
Page 5
Le catene di sospensione devono essere installate con un angolo di 45° come indicato in fig.I-A. ventilatore inclinerà naturalmente all’indietro durante il funzionamento. Se si usano catene molto lunghe per sospendere l’unità, potrebbe verificarsi un effetto pendolo. In questo caso, devono essere previste delle catene aggiuntive attaccare agli...
9. SCHEMI COLLEGAMENTO ELETTRICO • Assicurarsi che la macchina non sia alimentata durante ogni operazione di installazione, manutenzione o servizio! • L’installazione, i collegamenti elettrici e la manutenzione della macchina devono essere fatte da un installatore autorizzato e in accordo con le regole locali. •...
Ventilatori assiali AD MARCHIO: AERAULIQA MARCHIO: AERAULIQA MODELLI: MODELLI: AD1400A, AD1400B AD1400A, AD1400B sulla base del loro progetto e costruzione come quasi- sulla base del loro progetto e costruzione come quasi- macchine, sono progettati in conformità con I Requisiti macchine immesse sul mercato, sono progettati in Essenziali di Salute e Sicurezza (EHSRs) dell’ALLEGATO I,...
Translated from Original Instructions AD1400B High volume circulation fans INDEX GENERAL INFORMATION 2. PRECUTIONS 3. TYPE 4. MAIN FEATURES 5. DATA 6. DIMENSIONS AND CLEARANCES 7. COMPONENTS 8. INSTALLATION 9. WIRING DIAGRAM 9.1 CTRL-A (accessory on request) 9.2 CTRL-A2 (accessory on request) 9.3 CONTROL WITH EXTERNAL POTENTIOMETER (not supplied)
7. COMPONENTS Pos. Description Q.ty Impeller Casing Motor 8. INSTALLATION ATTENTION Make sure that the main supply to the unit is disconnected before performing any installation, service, maintenance or electrical work! The fan must be installed at a height of not less than 2.7m from the floor below. The fan must be installed with sufficient surrounding space for assembly/disassembly, cleaning and maintenance.
Page 12
The suspension chains must be installed at an angle of approx. 45° as shown in Fig. I-A. The fan will naturally tilt back under operation. If very long chains are used to suspend the unit, a pendulum effect may occur. In this case, additional chains should be attached to the bottom rear corners to prevent...
9. WIRING DIAGRAM • Make sure that the mains supply to the unit is disconnected before performing any installation, service, maintance or electrical work! • The installation and service of the unit and complete ventilation system must be performed by an authorized installer and in accordance with local rules and regulations.
Page 14
9.3 CONTROL WITH EXTERNAL POTENTIOMETER (not supplied) BROWN BLUE 3-core cable YELLOW-GREEN YELLOW BROWN EXTERNAL WHITE +10V POTENTIOMETER 6-core cable BLUE 0-10V ≥10kΩ BLACK GND (NOT SUPPLIED) 9.4 CTRL-XWS (accessory on request) BROWN BLUE 3-core cable YELLOW-GREEN CTRL-XWS BLUE 0-10V 6-core cable BLACK GND WHITE +10V...
Page 15
AD axial fans BRAND: AERAULIQA BRAND: AERAULIQA MODELS: MODELS: AD1400A, AD1400B AD1400A, AD1400B on the basis of its design and construction as partly on the basis of its design and construction of partly completed machines brought onto the market, is designed...
Page 16
Sede operativa/Warehouse-Offices: via Mario Calderara 39/41, 25018 Montichiari (Bs) - Sede legale/Registered office: via Mario Calderara 39/41, 25018 Montichiari (Bs) C.F. e P.IVA/VAT 03369930981 - REA BS-528635 - Tel: +39 030 674681 - Fax: +39 030 6872149 - www.aerauliqa.it - www.aerauliqa.com - info@aerauliqa.it Aerauliqa S.r.l.
Need help?
Do you have a question about the AD1400B and is the answer not in the manual?
Questions and answers