Advertisement
Quick Links
PRODUCT NAME: Brody Entry Cabinet
ITEM NUMBER: KE004 (KE002/KE003)
ASSEMBLED DIMENSIONS : 82"H x 40"W x 18.5"D
Ships in two cartons:
Base & Hutch
WARNING
ANCHORING HARDWARE INCLUDED
Serious or fatal crushing injuries can occur from a furniture tip-over
Prevent tipping accidents. Anchor your furniture.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 10-25-2024
Tip-Over Hazard
Phillips Screwdriver, Pencil, Allen Wrench
ASSEMBLY TIME: 5 minutes or less
ASSEMBLED WEIGHT: 339 lbs.
Ltr.
Qty.
Hardware/Components Included
A
2
B
8
8
C
D
2
E
8
1
F
G
1
1
(G)
LEVELERS: Base is equipped with Rotary
Levelers installed under each leg. If necessary
adjustments may be made by carefully lifting
applicable corner and turning Levelers clock-
wise/counterclockwise.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
REQUIRED TOOLS:
Wall Anchoring
(Anti-tip) L-Brackets
100mm x 100mm x 12mm
Long Screws
M4 x 30mm
Short Screws
M4 x 19mm
Connector Plates
45mm x 25mm x 2mm (thick)
Connector Plate Screws
M7 x 15mm
Hutch
Base
MADE IN VIETNAM
Page 1 of 4
Advertisement
Related Manuals for Ballard Designs Brody KE004
Summary of Contents for Ballard Designs Brody KE004
- Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Brody Entry Cabinet REQUIRED TOOLS: ITEM NUMBER: KE004 (KE002/KE003) Phillips Screwdriver, Pencil, Allen Wrench ASSEMBLED DIMENSIONS : 82”H x 40”W x 18.5”D ASSEMBLY TIME: 5 minutes or less ASSEMBLED WEIGHT: 339 lbs. Ltr. Qty.
- Page 2 Assemble in location for intended use. STEP 2: TIP-OVER HAZARD. HUTCH MUST BE SECURED TO CONSOLE USING CONNECTOR BRACKETS! Place Connector Brackets (D) over seam between both units, with upper holes over wood on base of Hutch (F) and lower holes over wood near top of Base (G). Insert Connector Plate Screws (E) and use a Phillips Screwdriver to fully tighten and secure plates into wood.
- Page 3 STEP 4: Pull unit away from wall, align L-Brackets (A) with marks on wall then anchor L-Bracket directly into Wall Stud using four Long Screws (B). LONG SCREWS into Wall Stud! Wall Stud Wall Stud STEP 5: Move unit back into place and slide under both L-Brackets (A). Attach using Short Screws (C) and a Phillips Screwdriver to firmly tighten.
- Page 4 Adjusting Door Alignment Doors should arrive level and aligned, howeve r, if adjustment is necessary follow these instructions to correct any issues. Process is the same for SINGLE OR DOUBLE doors. MOVE DOOR To Correct Vertical Alignment: Loosen Screw (A) then turn Screw (B) clock- wise/counterclockwise to adjust door.
Need help?
Do you have a question about the Brody KE004 and is the answer not in the manual?
Questions and answers