Page 1
YACHT ROUTER MICRO Installation Manual SERIES 5 The easiest way to stay online. version 1.1...
Page 2
Read carefully. For better understanding check video tutorials on our website. Register your product for software update notifications. Thank you.
The contents of this manual are well prepared by Locomarine Networks d.o.o. While we try to improve our equipment at all times, Locomarine Networks d.o.o. shall incur no liability based on contents, updates or modification of the contents, or the lack of contents in this manual.
IMPORTANT: It is solely on end-user to set transmitting power value for WIFI Booster to comply with regulations of country where product will be used. Regulations and online WIFI power calculators (EIRP - Equivalent Isotropically Radiated Power) are widely available on the Internet. Locomarine Networks d.o.o. cannot by responsible by any means for improper setup. Transmittion power is set and regulated via Yacht Router Control software.
PREFACE SAFETY INSTRUCTIONS ELECTRICAL SHOCK HAZARD: Do not open enclosure of the equipment if you are not qualified to do it. TURN OFF THE POWER IMMEDIATELY IF WATER LEAKS INTO THE EQUIPMENT OR AN OBJECT DROPS INTO THE EQUIPMENT: Continue operating the equipment could cause electrical shock or fire. Contact your nearest distributor or dealer for service. DO NOT DISASSEMBLE THE EQUIPMENT OR MODIFY THE EQUIPMENT: Improper disassemble or modification could cause electrical shock, fire, or personal injury.
CONTENT INTRODUCTION ABOUT YACHT ROUTER MICRO MODEL VERSIONS FEATURES WHAT IS IN THE PACKAGE PORTS AND CONNECTORS INDICATORS INSTALLATION CONNECTING POWER SUPPLY CONNECTING COMPUTER OR SWITCH INSTALLING ANTENNAS INSERTING SIM CARDS SETUP TECHNICAL SPECIFICATIONS HARDWARE DETAILS NETWORK DETAILS OUTLINE DRAWINGS...
1 Achieved with 9dBi outdoor antenna. As actual range depends on many factors Locomarine Networks d.o.o. do not guarantee specified range of connectivity. 2 Achieved with 9dBi outdoor antenna and VIP mobile provider. As actual range depends on many factors Locomarine Networks d.o.o. do not guarantee specified range of connectivity.
CHAPTER 1 - INTRODUCTION 1.5. PORTS AND CONNECTORS Yacht Router Micro is equipped with following ports and connectors. To access connectors remove plastic protection cover on front side of Yacht Router. DC in 8-30 V Mobile Mobile RS232 antenna 2 antenna 1 antenna (diagnostic port)
CHAPTER 1 - INTRODUCTION 1.6. INDICATORS Yacht Router Micro is equipped with multiple LED indicators. GPS - GPS indicator WLAN - WIFI activity on Vessel Network 1 ETH - Ethernet (LAN) port activity CAP - No special meaning PWR - Power indicator...
CHAPTER 2 - INSTALLATION 2.1. CONNECTING POWER SUPPLY There are four ways to power Yacht Router Micro: • DC in 8-30 V connector directly from vessel battery (with supplied DC power cable with connector 2 m) • DC in 8-30 V connector using supplied AC/DC power adaptor •...
Page 12
CHAPTER 2 - INSTALLATION 2.2. CONNECTING WIFI BOOSTER AND NETWORK EXTENDER If you purchased Yacht Router Micro without WIFI Booster or Network Extender, Ethernet LAN port on your Yacht Router Micro is set to be part of Vessel Network. You can connect computer directly using LAN cable or via WIFI.
Page 13
Network Extender is a device with WIFI and multiple LAN ports where you can set each LAN port to be part of Vessel Network or Backbone Network. This is very useful solution if you want to connect WIFI Booster to the system while keeping few LAN ports free to connect computer or other IP based devices. Network Extender Locomarine NETWORK EXTENDER SERIES 5 For more information check manual for WIFI Booster and Network Extender on our website www.yachtrouter.com...
CHAPTER 2 - INSTALLATION 2.3. INSTALLING ANTENNAS Yacht Router Micro is equipped with two mobile antennas and one GPS antenna. GPS antenna GPS antenna is equipped with 5 m cable. Antenna is waterproof so you can install it outdoor if necesarry. Mobile antennas To achieve best performance both mobile antennas should be connected.
CHAPTER 2 - INSTALLATION 2.4. INSERTING SIM CARDS Yacht Router Micro is equipped with two SIM card slots for standard SIM card size (15x25 mm). Both SIM cards are on top of each other. Lower slot is number 1 and upper number 2. Position SIM card lock into position as indicated on a photo.
Page 16
CHAPTER 2 - INSTALLATION If you want to insert second SIM card use upper slot. Position SIM card lock into position as indicated on a photo. Rotate SIM lock to insert SIM card into slot. Rotate SIM card lock into position as indicated on above Gently insert SIM card into upper slot.
CHAPTER 2 - INSTALLATION 2.5. SETUP Once you finished hardware installation you need to install Yacht Router Control software to setup and control Yacht Router: Once you install the software refer to USER MANUAL how to use it. It is available for download on our website www.yachtrouter.com You can also check VIDEO TUTORIALS on our website www.yachtrouter.com...
IMPORTANT: It is solely on end-user to set transmitting power value for all Yacht Router WIFI components to comply with regulations of country where product will be used. Regulations and online WIFI power calculators (EIRP - Equivalent Isotopically Radiated Power) are widely available on the Internet. It is solely up to user to comply with country regulations and Locomarine Networks d.o.o.
List of approved antennas: Omni Directional (pole), model Locomarine MOB 7 ANTENNA INSTALLATION: antennas from other products MUST NOT BE CO-LOCATED within 20 cm range to each other to satisfy FCC regulations. Antenna Installation. WARNING: It is installer’s responsibility to ensure that when using the authorized antennas in the United States (or where FCC rules apply); only those antennas certified with the product are used.
Need help?
Do you have a question about the 5 Series and is the answer not in the manual?
Questions and answers