Related Manuals for Locomarine 5 Series
Summary of Contents for Locomarine 5 Series
- Page 1 ADD-ON MODULE MOBILE EXPANDER Installation Manual The easiest way to stay online. version 1.0...
- Page 2 Read carefully. For better understanding check video tutorials on our website. Register your product for software update notifications. Thank you.
- Page 3 The contents of this manual are well prepared by Locomarine Networks d.o.o. While we try to improve our equipment at all times, Locomarine Networks d.o.o. shall incur no liability based on contents, updates or modification of the contents, or the lack of contents in this manual.
- Page 4 IMPORTANT: It is solely on end-user to set transmitting power value for WIFI Booster to comply with regulations of country where product will be used. Regulations and online WIFI power calculators (EIRP - Equivalent Isotropically Radiated Power) are widely available on the Internet. Locomarine Networks d.o.o. cannot by responsible by any means for improper setup. Trans- mittion power is set and regulated via Yacht Router Control software.
- Page 5 PREFACE SAFETY INSTRUCTIONS ELECTRICAL SHOCK HAZARD: Do not open enclosure of the equipment if you are not qualified to do it. TURN OFF THE POWER IMMEDIATELY IF WATER LEAKS INTO THE EQUIPMENT OR AN OBJECT DROPS INTO THE EQUIPMENT: Continue operating the equipment could cause electrical shock or fire. Contact your nearest distributor or dealer for service. DO NOT DISASSEMBLE THE EQUIPMENT OR MODIFY THE EQUIPMENT: Improper disassemble or modification could cause electrical shock, fire, or personal injury.
-
Page 6: Table Of Contents
CONTENT INTRODUCTION ABOUT MOBILE EXPANDER MODEL VERSIONS WHAT IS IN THE PACKAGE PORTS AND CONNECTORS INDICATORS INSTALLATION CONNECTING POWER SUPPLY CONNECTING MOBILE EXPANDER TO YACHT ROUTER STANDARD INSTALLING ANTENNAS INSERTING SIM CARDS SETUP TECHNICAL SPECIFICATIONS HARDWARE DETAILS OUTLINE DRAWINGS... -
Page 7: About Mobile Expander
CHAPTER 1 - INTRODUCTION 1.1. ABOUT MOBILE EXPANDER Mobile Expander s5 (Mobile Expander in further text) is add-on module to the various Yacht Router models. It will give you ability to connect Yacht Router to mobile networks (4G/3G/2G). With dual SIM card slot, you can use two SIM cards from same or different mobile provider. Mobile Expander cannot operate without Yacht Router. -
Page 8: What Is In The Package
List of all included components is enclosed in the package. - Mobile Expander, ME-S05 or ME-S05-US, 1 pcs - Locomarine MOB 7 antenna (2G/3G/4G, swivel, indoor), 4G-A-02, 2 pcs - Locomarine GPS 3 antenna, GP-S-3, 1 pcs - CAT5 cable (with connectors, 1m), CAT5-02, 1 pcs - PoE injector, CAT5P-03, 1 pcs - AC/DC power supply 24V/0.8A, PSU-05, 1 pcs... -
Page 9: Ports And Connectors
CHAPTER 1 - INTRODUCTION 1.4. PORTS AND CONNECTORS Mobile Expander is equipped with following ports and connectors. To access connectors remote plastic protection cover on front side of Mobile Expander. DC in 8-30 V Mobile Mobile RS232 antenna 2 antenna 1 antenna (diagnostic port) Reset... -
Page 10: Indicators
CHAPTER 1 - INTRODUCTION 1.5. INDICATORS Mobile Expander is equipped with multiple LED indicators. GPS - GPS indicator WLAN - WIFI activity on Vessel Network 1 ETH - Ethernet (LAN) port activity CAP - No special meaning PWR - Power indicator... -
Page 11: Connecting Power Supply
CHAPTER 2 - INSTALLATION 2.1. CONNECTING POWER SUPPLY There are few ways to power Mobile Expander: • DC in 8-30 V connector directly from Yacht Router DC out (with supplied DC power cable with connectors 0.3 m) • DC in 8-30 V connector directly from vessel battery (with supplied DC power cable with connector 2 m) •... -
Page 12: Connecting Mobile Expander To Yacht Router Standard
CHAPTER 2 - INSTALLATION 2.2. CONNECTING MOBILE EXPANDER TO YACHT ROUTER STANDARD There are two most common ways to connect Mobile Expander to the Yacht Router Standard. IMPORTANT It is important to connect Mobile Expander via Ethernet cable to any Backbone port on the Yacht Router. On the following photo Mobile Expander is powered using supplied 0.3 m cable directly from the Yacht Router. - Page 13 CHAPTER 2 - INSTALLATION On the following photo Mobile Expander is powered using Power-over-Ethernet injector (supplied with the Mobile Expander). This method is very useful when you want to install Mobile Expander on a remote location (e.g. close to the radar arch to minimize coax cable loss between Mobile Expander and outdoor antennas). You can connect maximum two Mobile Expanders to the Yacht Router Standard.
- Page 14 CHAPTER 2 - INSTALLATION On a following photo you can see Yacht Router Standard equipped with two Mobile Expanders and WIFI Booster.
-
Page 15: Installing Antennas
CHAPTER 2 - INSTALLATION 2.3. INSTALLING ANTENNAS Mobile Expander is equipped with two mobile antennas and one GPS antenna. GPS antenna GPS antenna is equipped with 5 m cable. Antenna is waterproof so you can install it outdoor if necessary. Mobile antennas To achieve best performance both mobile antennas should be connected. -
Page 16: Inserting Sim Cards
CHAPTER 2 - INSTALLATION 2.4. INSERTING SIM CARDS Mobile Expander is equipped with two SIM card slots for standard SIM card size (15x25 mm). Both SIM cards are on top of each other. Lower slot is number 1 and upper number 2. Position SIM card lock into position as indicated on a Rotate SIM card lock into position as indicated on above Rotate SIM lock to insert SIM card into slot. - Page 17 CHAPTER 2 - INSTALLATION If you want to insert second SIM card use upper slot. Position SIM card lock into position as indicated on a Rotate SIM lock to insert SIM card into slot. Rotate SIM card lock into position as indicated on above photo.
-
Page 18: Setup
CHAPTER 2 - INSTALLATION 2.5. SETUP As Mobile Expander is add-on module to the Yacht Router it is controlled by same software you use for your Yacht Router. If you did not already installed Yacht Router Control software you can download it here: Once you install the software refer to USER MANUAL how to use it. -
Page 19: Technical Specifications
CHAPTER 3 - TECHNICAL SPECIFICATIONS 3.1. HARDWARE DETAILS Mobile network Integrated modems: 1 SIM card slots: 2 SIM card size: Mini SIM Antenna connector type (on device): SMA female Sensitivity of included antennas: 4 dB Europe/Africa/Asia/Oceania modem: 2G category: Class12 3G category: R7 (21 Mbps downlink, 5.76 Mbps uplink) 4G category: 4 (150 Mbps downlink, 50 Mbps uplink) 2G bands: 2/3/5/8 (1900/1800/850/900) -
Page 20: Outline Drawings
CHAPTER 3 - TECHNICAL SPECIFICATIONS 3.2. OUTLINE DRAWINGS All dimensions in mm. - Page 21 IMPORTANT: It is solely on end-user to set transmitting power value for all Yacht Router WIFI components to comply with regulations of country where product will be used. Regulations and online WIFI power calculators (EIRP - Equivalent Isotopically Radiated Power) are widely available on the Internet. It is solely up to user to comply with country regulations and Locomarine Networks d.o.o.
- Page 22 List of approved antennas: Omni Directional (pole), model Locomarine MOB 7 ANTENNA INSTALLATION: antennas from other products MUST NOT BE CO-LOCATED within 20 cm range to each other to satisfy FCC regulations.
- Page 23 www.yachtrouter.com...