Polycom VSX 7000s Setup Manual

Hide thumbs Also See for VSX 7000s:

Download this manual

Revolabs HD Single / Dual Channel System — Polycom VSX 7000s Setup Guide

This setup guide will guide you through the steps needed to properly connect a

Revolabs HD Single or Dual Channel System to a Polycom VSX 7000s video codec.

It is important to carefully follow these instructions in order and completely.

Note:

Otherwise your Revolabs Microphone System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding.

Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs HD Single or Dual Channel System

2. Polycom VSX 7000s video codec

3. QTY 1 3.5mm unbalanced male connector to dual RCA male connector

cable*

* 07-35MUTODRCA-01 6' 3.5mm unbalanced male connector to dual RCA male

connector cable available from Revolabs

Need help?

Do you have a question about the VSX 7000s and is the answer not in the manual?

Page 1 This setup guide will guide you through the steps needed to properly connect a Revolabs HD Single or Dual Channel System to a Polycom VSX 7000s video codec. It is important to carefully follow these instructions in order and completely.
Page 2 2. Insert the dual RCA male connectors into the red and white AUDIO INPUT AUX ports. 3. Verify that DIP Switch #3 (mic/line) is “OFF” Configuring the Polycom VSX 7000s Video Codec 1. Select SYSTEM 2. Select ADMIN SETTINGS 3. Select AUDIO 4.