Page 2
Congratulations on the purchase of your new Kraus plumbing fixture! Please keep the box and packaging materials until your product is completely installed. If you have any questions, require technical assistance or have any problems with your product: STOP DO NOT RETURN TO STORE Please contact our Customer Service Team 1-800-775-0703 / customerservice@kraususa.com...
Prior to Installation: · Make sure you have all necessary parts by checking the diagram and parts list. If any part is missing or damaged, please contact Kraus Customer Service at 800-775-0703 for a replacement. · Read all instructions and safety warnings and ensure you have all tools, parts, and equipment necessary for a safe installation.
Page 4
2.5 mm Hex Wrench Aerator Key 3-Way Connector 1/4 to 3/8 Connector x 2 EZ-Weight Plastic Stabilizing Base For technical assistance or replacement parts, please contact Kraus Customer Service and one of our representatives will be happy to help: Toll-Free: 800-775-0703 or customerservice@kraususa.com...
Faucet Dimensions 4 3/4" 10 1/2" (267mm) (120mm) 8 1/2" (216.9mm) 2 1/8" (55mm) Installer Tip: Shut off main water supply before installing new faucet.
Page 6
Step 1. Install the faucet assembly Before installation, ensure that the flange (D) is placed on the bottom of the new faucet assembly (B). Insert the faucet body and all hoses through the hole in the sink. 1. Install the pull down hose with connector first.
Page 7
Step 3. Connecting the filter connection and water line Connect the 1/4 in. water line from the filtration system by pushing the line into the connector (G). Pull down on the 1/4 in. line slightly to ensure the quick connect fitting has engaged.
Page 8
Step 4. Attach the counterweight Install the weight on the marked area of the spray hose. Marked Area...
Page 11
Step 7. Connect the waterlines Thread the nut (1) on the supply line onto the outlet of the water supply valve (2) and tighten with wrench. Do not overtighten. NOTE: Please make sure filter washers are installed before connecting to the main valve. Step 8.
Troubleshooting If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps: PROBLEM CAUSE ACTION Locking nut has come loose or Leakage under faucet handle Remove button located at top of handle. cartridge needs to be reseated.
Page 14
(5) years from the date of purchase. Any product reported to the authorized dealer or to Kraus as being defective within the warranty period will be repaired or replaced with a product of equal value at the option of Kraus.
Page 15
12 Harbor Park Drive Port Washington, NY 11050 Toll-free 800-775-0703 Customerservice@kraususa.com If you are a plumbing contractor or trade professional, please contact a Kraus Pro Representative at: Kraus USA Plumbing, LLC 12 Harbor Park Drive Port Washington, NY 11050 516-801-8955 Proservice@kraususa.com...
Page 16
IMPORTANT Register Your Kraus Product Activate Your Warranty Access Premium Customer Support Get Product Information REGISTER TODAY http://www.kraususa.com/registration www.kraususa.com...
Page 18
Congratulations on the purchase of your new Kraus plumbing fixture! Please keep the box and packaging materials until your product is completely installed. If you have any questions, require technical assistance or have any problems with your product: STOP DO NOT RETURN TO STORE Please contact our Customer Service Team 1-800-775-0703 / customerservice@kraususa.com...
Prior to Installation: Make sure you have all necessary parts by checking the diagram and · parts list. If any part is missing or damaged, please contact Kraus Customer Service at 800-775-0703 for a replacement. · Read all instructions and safety warnings and ensure you have all tools, parts, and equipment necessary for a safe installation.
Tools Required Adjustable Wrench Drill Tape Measure Safety Goggles Utility Knife Permanent Marker Cut Resistant Gloves Care & Maintenance To keep the product clean & shining, follow the steps below: Rinse with clean water & dry with a soft cloth. ACID Do not clean with soaps, acid, polish, abrasives or harsh cleaners as use of such products may affect product performance or void the warranty.
Page 21
Diagram and Parts List Tee Adapter Manifold Polypropylene Cartridge Compressed Carbon Cartridge Quick Connect Lock Tab Mounting Screw & Anchor x 3 Tubing 1/4" x 8' 3x AA Batteries Battery Compartment...
Dimensions and Specifications 4 7/8" (125mm) 9 1/2" (240mm) 15 3/4" (400mm) Flow Rate 0.7GPM Capacity: 700 gallons NOTE: Depending on local water quality and use environment, the actual filtered water flow rate and total filtered water volume will vary. Min static pressure: 40 psi (275.8 kPa) Max static pressure: 120 psi (827.4 kPa) Inlet Water Temperature 41°...
Page 23
Step 1. Turn off the cold water supply and Tee Adapter turn on the faucet to relieve the water pressure and drain water from the water line. Disconnect the cold water supply line from the cold water supply valve. Install the tee adapter to the cold water supply valve.
Step 2. Using the mounting template, mount Fasteners the manifold. Align the mounting Cabinet holes of the manifold at the proper Wall mounting location. Mark the hole locations with a permanent marker. Place the manifold aside and pre-drill the mounting holes, if necessary, depending on the fasteners selected.
Page 25
Step 3. Insert the batteries into the battery compartment by lifting up the tabs. Drill 1/4" Hole Drill a 1/4" hole in the wall a few inches away from your filtration system. Place the anchor inside the hole and then Screw fasten the battery compartment to the wall by screwing it into the anchor.
Page 26
Step 4. Connect the tubing. Wet one end of the tubing sections with water and press it firmly into the inlet port of the filter head. Wet the other end of the tubing and press it firmly into the tee adapter. Repeat for the other end of tubing, pressing one end into the outlet port of the filter head and the other end into the filtered water faucet supply.
Page 27
Step 5. Install the filter cartridges. Write the date on the new filter cartridge label. Remove the cap from the filter cartridge and discard. Inspect the O-rings cartridge for any damage. Make sure both sets of O-rings are present and are positioned correctly.
Step 7. Display & Reset: After installing new filters push and hold the settings button for 3 seconds. Filter 1 icon will blink. Push the reset button and hold for 3 seconds and the icon will reset to full capacity. Push the settings button again and filter 2 icon will blink.
Page 29
Troubleshooting If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps: PROBLEM CAUSE ACTION Water leaks between the An O-ring is damaged, dirty, or Turn off the water supply, and relieve filter head and the filter cartridge.
Replacement Parts Replacement Parts List Part # Source 1. Quick Connect Lock Tab KP26063 2. Mounting Screws & Anchors Keruichuang & Shengfa KP26061 3. Tubing 1/4" x 8' Zhongdenuo KP26062 4. Tee Adapter Meigu KP26064 5. Compressed Carbon Cartridge KF-2CB Filtertech 6.
Page 31
Performance Data Sheet (based on VOC surrogate testing) Substance Influent Challenge Minimum % Reduction or Maximum Concentration mg/L Product Water Concentration Requirement mg/L alachlor 0.050 0.001 atrazine 0.100 0.003 benzene 0.081 0.001 carbofuran 0.190 0.001 carbon tetrachloride 0.078 0.0018 0.077 0.001 chlorobenzene chloropicrin...
Page 32
This warranty is non-transferable. Kraus warrants the structure and finish of the Product to be free from defects in material and workmanship under normal usage for a period of one (1) year from the date of purchase by a trade professional or end-user of the Product from an authorized Kraus dealer.
Page 33
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY DOES NOT COVER, AND KRAUS USA PLUMBING, LLC SHALL NOT BE LIABLE FOR, ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING LABOR CHARGES TO REPAIR, REPLACE, INSTALL OR REMOVE THIS PRODUCT), WHETHER ARISING OUT OF BREACH OF ANY EXPRESS OR IMPLIED WARRANTY, BREACH OF CONTRACT, TORT, OR OTHERWISE.
Page 34
IMPORTANT Register Your Kraus Product Activate Your Warranty Access Premium Customer Support Get Product Information REGISTER TODAY http://www.kraususa.com/registration www.kraususa.com...
Need help?
Do you have a question about the Britt KFF-1691 and is the answer not in the manual?
Questions and answers