Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Silvertel EVALPOE30W
Summary of Contents for Silvertel EVALPOE30W
- Page 1 Silvertel EVALPOE30W Rev 4 Evaluation Board User Manual Rev 4.0 – April 2012...
-
Page 2: Table Of Contents
Using the Board Typical Application ....................6 EVALPOE30W REV 4R - Evaluation Board Schematic ........7 Link settings ......................7 2 Table of Figures Figure 1: Board Layout ....................3 ... -
Page 3: Introduction
EVALPOE30W Rev 4 - Evaluation Board User Manual Introduction This manual is intended to be a guide to using the “EVALPOE30W Rev 4R” evaluation board with Silvertel Powered Device (PD) modules. The EVALPOE30W evaluation board can be powered using the spare pair in the CAT5e cable (pins 4 &... -
Page 4: Figure 1: Board Layout
EVALPOE30W Rev 4 - Evaluation Board User Manual Ag5000 - For Class 3 programming, LK3 should be fitted between the “b” and centre pins, LK6 should be fitted, for Class 0 remove both links. Ag5100 - LK3 should be fitted between the “a” and centre pins, LK6 should be removed. -
Page 5: Pd Output Selection
The secondary output (VOUT 2 – 0V 2) will track the adjusted primary output voltage. The EVALPOE30W board has an adjust link LK7 and two resistors R9 (100K) and R10 (0R) which allows the output to be adjusted to its maximum and (Ag5100) minimum values. -
Page 6: Minimum Load
The PD module requires a minimum load of 200mA to maintain normal operation. The EVALPOE30W board if fitted with a 200mA load which can be applied by fitting LK10. If the external load connected to the board always exceeds 200mA, then this link does not need to be fitted. -
Page 7: Using The Board
EVALPOE30W evaluation board (J1) via a CAT5e crossover cable. The data output of the EVALPOE30W evaluation board is connected to the data port of the ethernet camera via a short CAT5e patch cable. The +12V (parallel configuration) power output from the EVALPOE30W evaluation board (J7) connects to the dc input of the Vivotek PZ6122 ethernet camera. -
Page 8: Evalpoe30W Rev 4R - Evaluation Board Schematic
EVALPOE30W Rev 4 - Evaluation Board User Manual 6.2 EVALPOE30W REV 4R - Evaluation Board Schematic 6.3 Link settings LK1 – Connects VA+ to BR1 + LK2 – Connects VA- to BR1 - LK3 – Selects Class 3 programming (Ag5000) or “at” PSE detection (Ag5100) LK4 –... - Page 9 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Silvertel EVALPOE30W...
Need help?
Do you have a question about the EVALPOE30W and is the answer not in the manual?
Questions and answers