Craftsman 10872 - Mini Circular Saw Operator's Manual page 33

Tool wlll not
power on
AC power cord is not fully Properly Install power cord
Inserted Into the AC outlet plug Into the AC outlet
or has fallen out
No power on AC outlet Find circuit breaker panel
and verify that the breaker
controlling your outlet Is ON,
if the breaker continues to
switch to the off position,
contact a qualified
electrician to locate the
cause,
No power on AC outlet. Locate GFI outlets and verify
Your outlet may be a GFI that the "RESET_' t ab is
type or it may be pushed In. If the GFI RESET
downstream from another tab pops out again,
GFI outlet, contact a qualified
electrician to locate the
cause.
Tool power switch
(Paddle) will not
activate the tool,
PowerCord Damaged
Safety Interlock Is not
activated properly.
Safety Interlock may be
Jammed°
Remove powerplug from the
AC outlet and Inspect the
plug and the length of the
cord. Do not a_empt repair
of the power cord, Return for
serviceor discard°
Read Operator's Manual.
Excesslve paddle pressure
may jam the paddle release.
Slide the paddle lock toward
the rear of the tool fully,and
then squeeze the paddle,
Unplug the tooll Turnthe
tool overand Inspect the
safetyInterlock and paddle.
Removeany woodchipsor
debris that may have
accumulated.
33