Keep these pages open when studying the oper- 2. Description ating instructions. 3. Accessories In these operating instructions, the PR 26 rotating laser 4. Technical data is referred to as “ the tool ”. 5. Safety precautions Location of identification data on the tool 6.
Inclination can be set up in alignment with given marks Automatic leveling (within 10°): The tool levels itself by pressing the X- and Y-keys on the PRA 26 or PR 26. automatically after switching on. The laser beam is emit- ted only when the specified accuracy has been achieved.
Many tasks can be carried out much more efficiently – PUA 80 charger and PRA 801 battery pack when the appropriate accessories for the PR 26 are used. – PA 375 batter board adapter, PA 377 tripod and facade The following accessories are available: adapter –...
Use the tool only within its specified limits. ● 5.1 Basic information concerning safety Check that your PR 26 is being controlled by your ● In addition to the information relevant to safety given in PRA 26 and that it is not reacting to commands from each of the sections of these operating instructions, the any other PRA 26 in use on the construction site.
Do not allow the batteries to fall into children's hands. ● ● Do not overheat or incinerate the batteries. They may damaged, have it repaired at a Hilti service center. ● explode or release toxic substances. The accuracy of the tool must be checked after it has ●...
– A further press of the key switches the tool back to the rotation speed control key (PR 26 or PRA 26). After long line. switching on, the PR 26 is set to rotate at medium speed, – The next press of the key switches the tool back to the as standard.
Page 11
5–50 m). PRA 26. – Check that no obstacles prevent communication – As long as the PR 26 is not in line laser mode, it then between the PR 26 and the PRA 26. switches automatically to medium rotation speed and –...
Page 12
PR 26 must be set up accurately. The The PR 26 and PRA 26 are not paired when supplied. PR 26 must be set up so that the correct axis (X or Y) Each unpaired rotating laser receives commands from is positioned in the direction in which alignment is to be any unpaired laser receiver.
Use can be made of the Hilti Calibration Service at any 8.1.1 Checking procedure time, but checking at least once a year is recommended. 1. Set up the tool in the horizontal plane at a distance of...
Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must be properly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back old tools and appliances for recycling.
Consult the dealer or an experienced TV/radio tech- ● nician for assistance. Changes or modifications not expressly approved by Hilti could restrict the user's right to operate the equip- ment. 13. EC conformity Designation: Rotating laser...
Need help?
Do you have a question about the PR 26 and is the answer not in the manual?
Questions and answers