Setup.ini - Concurrent - Texas Instruments TINSPIRE Software Installation Manual

Setup.ini - Concurrent

Important information about the setup.ini
1. Be sure to acquire the correct setup.ini for your operating
system. The content is the same for both Mac® and PC but the
file structure (end of line characters) are not compatible and will
not work correctly with the wrong operating system.
2. Use a non-formatting text editor such as Notepad on the PC and
TextEdit on the Mac® when updating the setup.ini file. Do not
use a word processor such as Microsoft® Word.
3. Check the setup.ini to make sure all the fields are the same in
your version as this document.
The field and values shown here are accurate with the setup.ini
version at the time this document was written, however, there is
a possibility that a change may be made in the posted setup.ini
before it is reflected in this guide.
If you find different fields and it is not clear how to proceed,
contact the SSC at education.ti.com/go/softwarecenter before
continuing.
4. For Windows® the setup.ini must be in the same directory as
the TI-Nspire™ installer executable. On the Mac® the setup.ini
must be in the /tmp directory.
5. The content of the setup.ini is the same for volume and
concurrent licenses but there are some differences in the fields
and values used. This section will discuss the correct values for
the concurrent license.
6. If you are using the same setup.ini for multiple products be sure
to clear values that do not correspond to the new product. For
example, if you first install the Student Software and set the
TINSPIRE_SS value to CAS and then later are editing the
setup.ini to install the Teacher Software, remember to clear the
TINSPIRE_SS value.
34 Installing and Activating TI Software