Deployment; Activation - Texas Instruments TINSPIRE Software Installation Manual

 ACTIVATION_TIME_LIMIT
#Configuration item that sets a fixed amount of time (seconds) to obtain
random value when 3 attempt silent activation. Default value is set to 10
minutes.
#Accepted values: seconds
ACTIVATION_TIME_LIMIT=600
------------------------------------------
License types: Volume and Concurrent
Comment: This field specifies the wait time between activation retries.
The system will automatically try to activate up to three times. This
value provides way to determine how many seconds to wait before
retrying the activation.

Deployment

There are many deployment packages you can use to distribute the
software. Texas Instruments does not make any recommendations or
endorse any particular brand or describe steps for using these tools.
Please see your deployment tool's instructions for more information.
If you experience any problems when deploying TI software, contact the
Software Service Center at education.ti.com/go/softwarecenter or
1-800-TI-CARES.
Note: If you did not choose SILENT=YES in the setup.ini, the user will see
the same install screens as when installing a single license user. Also, the
license information will not be pulled from the setup.ini file.

Activation

Activation either occurs automatically after deployment or when the user
runs the client depending on the setting of 'Activate' in the setup.ini.
If you set Silent=Yes in the setup.ini, the user will not see any install
screens or questions when they launch the software for the first time. If
Silent was set to NO, the user will see the same screens as in the basic
install.
If the license number was entered in the setup.ini and located in the
same directory as the client application, the user will not be prompted to
enter the license.
Note: If you specified activation to occur at deployment but you have
individual machines that failed because they were not connected to the
Internet, you have to run a basic install on these machines once they are
connected.
If you have a machine that cannot be connected to the Internet for
activation, see Web Portal Activation.
28 Installing and Activating TI Software