Advertisement

Aqara T1 Manual

Product Introduction

Product Introduction

*This device requires a compatible Zigbee 3.0 hub. Some features require a specific hub. For a detailed list, visit www.aqara.com/support.

Quick Setup

  1. Please add the Hub to the app according to the Hub Quick Start Guide.
  2. Please open the app, tap "Home" and then tap "+" at the top right corner to enter "Add Device (Accessory)" page. Select "Water Leak Sensor T1", and add it according to instructions.
  3. Need help? Visit www.aqara.com/support.

*If the connection fails, please move the device closer to the Hub and try again.

Installation

Effective Range Test: Single press the reset button on the device at your desired position. If the Hub makes voice prompts, it indicates that the device can communicate effectively with the Hub.

*Avoid metal surface to maximize signal strength.

Option 1:Place it directly on the surface where you need to monitor water leak.
Installation - Option 1

Option 2:Use a hex screwdriver to loosen the probes and connect to cables for more smart scenes.
Installation - Option 2

*The antenna is right above the water drop icon.

Specifications

Model: WLS-S01

Dimensions: 50 × 50 × 15mm (1.97 × 1.97 × 0.59 in.)

Wireless Protocol: Zigbee 3.0

Battery: CR2032

Operating Temperature: -10° - +55℃ (14° - 131℉)

Operating Humidity: 0 - 100% RH

*Read this Quick Start Guide carefully before use and keep it for future reference.

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Aqara T1 Manual

Advertisement

Need help?

Need help?

Do you have a question about the T1 and is the answer not in the manual?

Questions and answers

Table of Contents