Aqara Door and Window Sensor Quick Start Guide

Product Introduction

Aqara Door and Window Sensor detects the open and close state of doors or windows through the distance between the sensor unit and the magnet. It consumes low energy. No tools required, and simply peel and stick.

• A hub is required.
• Aqara Hub is required to enable Aqara Door and Window Sensor to work with HomeKit technology. See www.aqara.com for more details.
• This product is for indoor use only.

Reset Button
Long Press for 3s: Reset/Connect to Network
Single Press: Effective Range Test

Quick Setup

1. Before activating the accessory, please make sure you have the Aqara Home app downloaded and Aqara hub installed.
2. Please open the app, tap "Home" and then tap "+" in the top right corner to enter "Add Device (Accessory)" page. Select "Door and Window Sensor", and add it according to instructions.

* If the connection fails, please move the accessory closer to the Hub and try again.

Installation

Effective Range Test: Single press the reset button on the accessory at your desired position. If the Hub makes voice prompts, it indicates that the accessory can communicate effectively with the Hub.

* Avoid metal surface to maximize signal strength.

1. Remove the protective film.
   
2. During installation, try to align the marker line of the sensor unit and the magnet.
   
3. Stick to doors or windows (It is recommended to install the sensor unit on the unmovable surface, the magnet on the movable surface, and make sure the installation gap is less than 22 mm when doors or windows are closed).
   

* Keep the surface clean and dry.

Specifications

Model: MCCGQ11LM
Dimensions: 41 × 22 × 11 mm (1.61 × 0.87 × 0.43 in.)
Wireless Protocol: Zigbee
Battery: CR1632
Maximum Detection Distance: 22 mm (0.87 in.)
Operating Temperature: -10° – +50°C (14° – 122°F )
Operating Humidity: 0 – 95% RH, no condensation
Maximum Transmit Power (Zigbee): 9.99 dBm
Working Frequency: 2400 MHz – 2483.5 MHz
Online Customer Service: www.aqara.com/support
Email: support@aqara.com

1. This product is NOT a toy. Please keep children away from this product.
2. This product is designed for indoor use only. Do NOT use in humid environments or outdoors.
3. Beware of moisture, do NOT spill water or other liquids onto the product.
4. Do NOT place this product near a heat source. Do NOT place it in an enclosure unless there is normal ventilation. Do NOT attempt to repair this product by yourself. All
5. repairs should be performed by an authorized professional. This product is only suitable for improving the entertainment, convenience of your home life and
6. reminding you about the device status. It should NOT be used as security equipment for home, building, warehouse or any other places. If a user violates the product use instructions, the manufacturer will NOT be liable for any risks and property losses.

Manufacturer: Lumi United Technology Co., Ltd.
Address: 8th Floor, JinQi Wisdom Valley, No.1 Tangling Road, Liuxian Ave, Taoyuan Residential District, Nanshan District, Shenzhen, China.