Aqara Motion Sensor Quick Start Guide

Product Introduction

Aqara Motion Sensor detects human movement with passive infrared. It works with other smart accessories to set various scenes, such as, turning on or off lights automatically when it detects activity or inactivity. It consumes low energy. No tools are required to install it, and you can simply place or stick it almost anywhere.

• A hub is required.
• Aqara Hub is required to enable Aqara Motion Sensor to work with HomeKit technology. See www.aqara.com for more details.
• This product is for indoor use only.

Reset Button
Long Press for 3s: Reset
Single Press: Effective
Range Test

Quick Setup

1. Please add the Hub to the app according to the Hub Quick Start Guide.
2. Please open the app, tap "Home" and then tap "+" in the top right corner to enter "Add Device(Accessory)" page. Select "Motion Sensor", and add it according to instructions.

* If the connection fails, please move the accessory closer to the Hub and try again.

Installation

Effective Range Test: Single press the reset button on the accessory at your desired position. If the Hub makes voice prompts, it indicates that the accessory can communicate effectively with the Hub.

* Avoid metal surface to maximize signal strength.

Option 1: Place the Motion Sensor where you need it.

Option 2: Remove the protective film (the round sticker is in the box), and stick it to the desired position.

Option 3: Stick the Motion Sensor to the stand, and stick the stand to where you need it.

* Keep the surface clean and dry.
* The recommended installation height is 1.2 m to 2.1 m. If the installation height is below 1.2 m, the detection area will decrease; if above 2.1 m, the detection area might have blind spots.

* Note that the lens should be aligned with the detection area when installing, and placed or pasted as close as possible to the edge of a table or cabinet.

Specifications

Model: RTCGQ11LM
Dimensions: 30 × 30 × 33 mm (1.18 × 1.18 × 1.30 in.)
Wireless Protocol: Zigbee
Battery: CR2450
Maximum Detection Distance: 7 m
Maximum Detection Angle: 170°
Operating Temperature: -10° – +45°C
Operating Humidity: 0 – 95% RH, no condensation
Online Customer Service: www.aqara.com/support
Email: support@aqara.com

Manufacturer: Lumi United Technology Co., Ltd.
Address: 8th Floor, JinQi Wisdom Valley, No.1 Tangling Road, Liuxian Ave, Taoyuan Residential District, Nanshan District, Shenzhen, China.