Aqara Water Leak Sensor Quick Start Guide

Product Introduction

Aqara Water Leak Sensor detects water leak and flooding and monitors the status of water leak. When the water leak or flooding occurs, it sends an instant alert notification via app. It also works with other smart accessories to automate your home.

• A hub is required.
• Aqara Hub is required to enable Aqara Water Leak Sensor to work with HomeKit technology. See www.aqara.com for more details.
• This product is for indoor use only.

Indicator Light Reset Button
Long Press for 5s: Reset/Connect to Network
Single Press: Effective Range Test

Quick Setup

1. Before activating the accessory, please make sure you have the Aqara Home app downloaded and Aqara hub installed.
2. Please open the app, tap "Home" and then tap "+" in the top right corner to enter "Add Device (Accessory)" page. Select "Water Leak Sensor", and add it according to instructions.

* If the connection fails, please move the accessory closer to the Hub and try again.

Installation

Effective Range Test: Single press the reset button on the accessory at your desired position. If the Hub makes voice prompts, it indicates that the accessory can communicate effectively with the Hub.

* Avoid metal surface to maximize signal strength.

Option 1: Place it directly on the surface where you need to monitor water leak.

Option 2: Use a hex screwdriver to loosen the probes, and connect to cables for more smart scenes.

* In order to ensure the dustproof and waterproof performance of the product, the back cover of the battery must be tightened before use, and the groove is at the same level as the probe.

* The antenna is right above the water drop icon.

Battery Replacement

1. Insert a coin into the groove of the battery cover and turn it counterclockwise to open the battery cover;
2. Put a new CR2032 button battery into the battery compartment, and pay attention to making the side with the"+" sign face out;
3. Close and tighten the battery cover, and ensure that the groove of the battery cover is aligned with the metal probes on both sides in a straight line;
   

Specifications

Model: SJCGQ11LM
Dimensions: 50 × 50 × 15 mm (1.97 × 1.97 × 0.59 in.)
Wireless Protocol: Zigbee
Battery: CR2032
Operating Temperature: -10° – +55°C (14° – 131°F)
Operating Humidity: 0 – 100% RH
Maximum Transmit Power (Zigbee): 9.99dBm
Working Frequency: 2400 MHz – 2483.5 MHz|
Online Customer Service: www.aqara.com/support
Email: support@aqara.com

Manufacturer: Lumi United Technology Co., Ltd.|
Address: 8th Floor, JinQi Wisdom Valley, No.1 Tangling Road, Liuxian Ave, Taoyuan Residential District, Nanshan District, Shenzhen, China.

1. This product is NOT a toy. Please keep children away from this product.
2. This product is designed for indoor use only. Do NOT use in outdoors.
3. Do NOT place this product near a heat source. Do NOT place it in an enclosure unless there is normal ventilation. Do NOT attempt to repair this product by yourself. All
4. repairs should be performed by an authorized professional. This product is only suitable for improving the entertainment, convenience of your home life and
5. reminding you about the device status. If a user violates the product use instructions, the manufacturer will NOT be liable for any risks and property losses