Table of Contents
Advertisement
TW100-BRV204 User Guide
IKE Phase 1
If you selected IKE, the following screen is displayed after the Traffic Selector screen.
IKE Phase 1 (IKE SA)
Direction
Local Identity
Remote Identity
Authentication
Encryption
IKE Exchange
Mode
Figure 52: VPN Wizard - IKE Phase 1
Select the desired option:
•
Initiator - Only outgoing connections will be created. Incoming
connection attempts will be rejected.
•
Responder - Only incoming connections will be accepted.
Outgoing traffic which would otherwise result in a connection
will be ignored.
•
Both Directions - Both incoming and outgoing connections are
allowed.
This setting must match the "Remote Identity" on the remote VPN.
IP address is the more common method.
This setting must match the "Local Identity" on the remote VPN.
IP address is the more common method.
•
RSA Signature requires that both VPN endpoints have valid
Certificates issued by a CA (Certification Authority).
•
For Pre-shared key, enter the same key value in both endpoints.
The key should be at least 8 characters (maximum is 128 charac-
ters). Note that this key is used for the IKE SA only. The keys
used for the IPsec SA are automatically generated.
Select the desired method, and ensure the remote VPN endpoint uses
the same method. The "3DES" algorithm provides greater security
than "DES", but is slower.
Select the desired option, and ensure the remote VPN endpoint uses
the same mode. Main Mode provides identity protection for the hosts
initiating the IPSec session, but takes slightly longer to complete.
Aggressive Mode provides no identity protection, but is quicker.
78
Advertisement
Table of Contents
