Table of Contents
Advertisement
Move
Enable/Disable
Copy
Delete
View Log
Adding a New Policy
1. To create a new VPN Policy, click the "Add" button on the VPN Policies screen. This will
start the VPN Wizard, as shown below.
•
If you prefer to use a single setup screen instead of a Wizard, click the Setup Screen
button. This is recommended for experienced users only.
•
Otherwise, click Next to continue. You will see a screen like the following.
There are 2 ways to change the order of policies:
•
Use the up and down indicators on the right to move the selected
row. You must confirm your changes by clicking "OK". If you
change your mind before clicking "OK", click "Cancel" to reverse
your changes.
•
Click "Move" to directly specify a new location for the selected
policy.
Use this to toggle the On/Off state of the selected policy.
If you wish to create a policy which is similar to an existing policy,
select the policy and click the "Copy" button.
Remember that the new policy must have a different name, and there can
only be one active (enabled) policy for each remote VPN endpoint.
To delete an exiting policy, select it and click the "Delete" button.
Clicking the "View Log" button will open a new window and display the
VPN log.
Figure 48: VPN Wizard - Start
VPN
73
Advertisement
Table of Contents
