Table of Contents
Advertisement
Quick Links
INSTALLATION & OPERATING
MANUAL
IGNITE XL EVOLVE
Models
• Ignite XL Evolve 1200 EVO1200-AU
• Ignite XL Evolve 1500 EVO1500-AU
• Ignite XL Evolve 1800 EVO1800-AU
• Ignite XL Evolve 2500 EVO2500-AU
The product is compliant with the local electrical standards of all countries where offered for sale by
Glen Dimplex and its subsidiaries.
VERSION X.1
7216870100 VERSION 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Glen Dimplex Real Flame Ignite XL Evolve 1200 EVO1200-AU
Summary of Contents for Glen Dimplex Real Flame Ignite XL Evolve 1200 EVO1200-AU
- Page 1 • Ignite XL Evolve 1500 EVO1500-AU • Ignite XL Evolve 1800 EVO1800-AU • Ignite XL Evolve 2500 EVO2500-AU The product is compliant with the local electrical standards of all countries where offered for sale by VERSION X.1 Glen Dimplex and its subsidiaries. 7216870100 VERSION 1...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Welcome . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Technical Specifications . -
Page 3: Welcome
WELCOME Please carefully read and save these instructions. Please record your model and serial numbers for future reference. Model and serial numbers can be found on the label located behind the front glass of your fireplace. Model Serial Number QR Code label (behind front glass) for the Flame Connect App Model and serial... - Page 4 WELCOME Do not use this appliance in series with a thermal control, a program controller, a timer or any other device that switches on the heat automatically, since a fire risk exists when the heater is accidentally covered or displaced. Ensure that furniture, curtains or other combustible material are positioned no closer than 1 meter from the appliance.
- Page 5 WELCOME CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out this appliance must not be supplied through an external switching device, such as a timer or connected to a circuit that is regularly switched on and off by the utility.
-
Page 6: Technical Specifications
TECHNICAL SPECIFICATIONS Electrical Requirements NOTE: A dedicated, properly fused 10 Amp circuit is required, rated for the appropriate voltage (230-240V). An isolation switch should also be incorporated in cases where the product plug is inaccessible after installation. WARNING: Construction and wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons. -
Page 7: Package Contents
PACKAGE CONTENTS Quantity Image Description EVO1200-AU EVO1500-AU EVO1800-AU EVO2500-AU Remote Control Medium Acrylic ~1.2 lb ~1.4 lb ~1.8 lb ~2.4 lb Crystals ~0.54 kg ~0.65 kg ~0.8 kg ~1.08 kg Large Acrylic Crystals Driftwood ~2.6 lb ~3.3 lb ~3.9 lb ~5.2 lb Tumbled Glass Embers ~1.2 kg... -
Page 8: Optional Accessories
• Ignite XL Evolve 2500 EVO2500-AU The product is compliant with the local electrical standards of all countries where offered for sale by VERSION X.1 Glen Dimplex and its subsidiaries. VERSION 1 Suction Cup Do not dispose of the suction cup after installation. -
Page 9: Installation
INSTALLATION Placement NOTE: It is recommended that the bottom of the unit be mounted between 127 mm and 1016 mm from the ground to maintain an optimized viewing angle of the flame. WARNING: The top of the fireplace must be installed a minimum of 609.6 mm from the ceiling. The fireplace must be installed a minimum of 127 mm from the ground. -
Page 10: Installation Instructions
INSTALLATION Installation Instructions NOTE: Two people are required for installation. 1. The fireplace is installed flush-mounted. (50.8 mm x 152.4 mm frame). Prepare a wall with a framed opening, following the dimensions shown in Figure 3. CAUTION: Decorative finishing material (such as brick) should be limited to 13 mm overhang to ensure adequate flow of heated air out of the firebox area. - Page 11 INSTALLATION Distance from the right side to the wiring inlet: EVO1200-AU, EVO1500-AU, EVO1800-AU EVO2500-AU 330.25 mm 508.4 mm 6. Drive four supplied mounting screws through the four mounting holes located on the inside surface of the fireplace chassis, into wall studs. (Figure 4) 7.
-
Page 12: Heater Hardware Disconnect
INSTALLATION Heater Hardware Disconnect The fireplace heater can be permanently disabled by removing the electronic jumper on the control board. NOTE: Heater hardware disconnect will permanently disable the heater and fan. Follow these instructions only when an installation without heat is required. Temporary disabling of the heater can be achieved through the hidden touch controls. -
Page 13: Mirrored Glass Installation
INSTALLATION Mirrored Glass Installation 1. Locate and remove the screws securing the mirrored glass bracket to the unit, along the top of the opening, and set bracket and screws aside. (Figure 7) 2. Remove the provided suction cup from the inside cavity of the unit (not included in units). -
Page 14: Media Arrangement
INSTALLATION Media Arrangement For the best results when using the supplied media, follow the instructions below. Figure 8 Tumbled Glass Media and Driftwood: NOTE: The driftwood is fragile. Ensure the driftwood is secure when placing it in the media bed, and keep a soft surface below the fireplace during installation. -
Page 15: Front Glass Installation
INSTALLATION Front Glass Installation NOTE: Install the front glass before the fireplace is powered on. If the unit is powered on before the glass is installed, a full power reset will be required to activate the hidden touch controls. 1. Ensure that the mirrored glass and the inside of the front glass is clean and free from particles and fingerprints. 2. -
Page 16: Operation
OPERATION General Operation WARNING: This electric firebox must be properly installed before it is used. This firebox operates with Comfort$aver technology, which automatically adjusts the fan speed and heater wattage to safely and precisely match the requirements of the room based on the thermostat setting. The heater operates such that once the room reaches the set point, the fan and heater will continuously run at a low level, to maintain the desired room temperature. - Page 17 OPERATION Press to turn on the unit or to put it in standby mode. Standby When the unit is turned back on, it will retain the previously used settings. Flame Effect Press to turn the flame effect and media on or off. Press to turn the heat on or off.
- Page 18 OPERATION Press repeatedly to cycle through the brightness and flicker modes. Solid H - High Brightness Brightness Solid L - Low Brightness Cycle H - High Brightness with flickering media and accent lights Cycle L - Low Brightness with flickering media and accent lights Press repeatedly to cycle through the 7 different flame themes: 1 - Base with orange and blue accents...
-
Page 19: Maintenance
MAINTENANCE Figure 16 Remote Control Battery Replacement 1. Remove battery cover of the remote control using a Philips screwdriver. 2. Correctly install the 3 Volt (CR2032 or similar) battery in the battery holder with the + side facing up. 3. Secure the battery cover using the previously removed screw. Batteries must be recycled or disposed of properly. -
Page 20: Troubleshooting
TROUBLESHOOTING For more troubleshooting, consult the Service Manual which can be found at www .realflame .com .au or www .realflame .co .nz Problem Display Cause Solution Ensure unit is receiving power No incoming power Check socket switch is on Ensure mains switch is on Fireplace does not turn on with the hidden touch controls Turn power off (from breaker or... -
Page 21: Wiring Diagrams
WIRING DIAGRAMS EVO1200-AU EVO1500-AU... - Page 22 WIRING DIAGRAMS EVO1800-AU EVO2500-AU...
-
Page 23: Warranty
REFERRED AS “GLEN DIMPLEX”). maintenance instructions), repairs or modifications by THIS LIMITED WARRANTY IS PROVIDED TO THE FIRST persons not authorised by Glen Dimplex, use of parts DOMESTIC PURCHASER OF A REAL FLAME ELECTRIC not supplied by Glen Dimplex, or damage or other FIRE. - Page 24 NZ: +64 9 274 8265 This product is protected by Intellectual property rights and patents owned by the Glen Dimplex Group on an international basis. The Glen Dimplex Group of Companies will actively protect these rights. c Glen Dimplex.
Need help?
Do you have a question about the Real Flame Ignite XL Evolve 1200 EVO1200-AU and is the answer not in the manual?
Questions and answers