Wiper Blade Replacement - Chevrolet CAMARO - 2010 Owner's Manual

3. With the latch open, pull the
wiper blade down towards the
windshield far enough to release
it from the J-hooked end of the
wiper arm.
4. Remove the wiper blade.
Allowing the wiper blade arm to
touch the windshield when no
wiper blade is installed could
damage the windshield. Any
damage that occurs would not
be covered by the vehicle
warranty. Do not allow the wiper
blade arm to touch the
windshield.
5. Reverse steps 1 through 3 for

wiper blade replacement.

The headlamp aiming system has
been preset at the factory.
If the vehicle is damaged in an
accident, the aim of the headlamps
may be affected and adjustment
may be necessary.
It is recommended that a dealer/
retailer adjust the headlamps. To
re-aim the headlamps yourself, use
the following procedure.
The vehicle should be properly
prepared as follows:
The vehicle should be placed so
the headlamps are 7.6 m (25 ft)
from a light colored wall.
The vehicle must have all four
tires on a level surface which is
level all the way to the wall.
The vehicle should be placed so
it is perpendicular to the wall or
other flat surface.
The vehicle should not have any
snow, ice, or mud on it.
The vehicle should be fully
assembled and all other work
stopped while headlamp aiming
is being performed.
The vehicle should be normally
loaded with a full tank of fuel and
one person or 75 kg (160 lbs)
sitting on the driver's seat.
Tires should be properly inflated.
Headlamp aiming is done with the
vehicle's low-beam headlamps. The
high-beam headlamps will be
correctly aimed if the low-beam
headlamps are aimed properly.